Ufree U-1733 Beard Hair Trimmer for Men Professional Instruction Manual

Ufree U-1733 Beard Hair Trimmer for Men Professional

BEFORE USE

This instruction is prepared for you to use the hair trimmer correctly. Please read it carefully before use. You only need to use it according to the simple suggestions in the instruction, which will not only bring you good service, but also extend the life of the hair trimmer.

SAFETY INSTRUCTION

Danger
Keep the adaptor dry

Warnings

• Before connecting the power supply, please make sure that the voltage marked on the product is consistent with the local power voltage.
• Do not charge continuously for a long time, or charge it when the temperature is lower than 0°C or higher than 40°C, otherwise the life of battery will be shortened.
• The product is only allowed to use the matching charging cable for charging. Do not use any accessories not provided by the company with the product.
• Before cleaning the hair trimmer under tap water, be sure to unplug the charger.
• If the power cord is damaged, it must be replaced with a special flexible cord or a special component purchased from the manufacturer or maintenance department
• When there is a stain on the body, use a soft cloth to dip the neutral detergent and wipe it. Do not use alcohol, gasoline or other chemicals to wipe the product.
• In case of abnormal conditions (such as abnormal smell, temperature and sound) during charging or use, the power supply shall be cut off immediately and stop using it. Please handle it according to the type of fault, and submit it to the maintenance department of our company for maintenance if necessary.

Product specification

HOW TO USE

• To charge the product, please insert the small plug of type-C charging cable into bottom socket, then insert the other end of the power cord into the transformer, as shown in Figure 1
  Note: when the transformer connector is greater than or equal to 6V, the product will not be charged)

• Connect the power supply, the charging indicator will flash blue, indicating that it is charging, as shown in Figure 2

• Charged for about 3 hours, when the indicator blue light is off, it indicates that the charging has been completed, as shown in Figure 3

• It is fully charged and can be used for more than 2.5 hours. When the indicator blue light flashes, it indicates that the power is insufficient and needs to be charged in time.

• When cutting hair, remove the protective cover of the cutting head as shown in Figure 4, turn on the switch of the cutting scissors, and the indicator blue light is on as shown in Figure 5. Then move the cutting scissors head slowly against the direction of hair growth, and move in a straight and circuitous way.

• Three specifications of comb row are attached: 1mm / 2mm / 3mm / 4mm which can be replaced at will according to the length of trimming

• When the product does not have electricity, it can be connected to the charger for direct use (plug and use)

• If the load is too large, it will automatically shut down (locked rotor protection).

HOW TO MAINTENANCE

• Before cleaning, always disconnect the power and turn off the product, take out the attached comb (if the comb row is used), wash it directly under the faucet, and gently brush the remaining hair on the blade and product surface with the provided cleaning brush
• After cleaning, in order to obtain better effect of the blade, if necessary, put each drop of lubricating oil in the left, middle and right of the blade head, and start the machine for several times to wipe the surface of blade head, so as to keep it sharp, rotate it lightly and prevent wear.
• When the hair trimmer is not in use ,cover the blade with protection sleeve to prevent damage.

QUESTIONS

DESCRIPTION

USING STEPS

PROTECT THE ENVIRONMENT

TO PROTECT THE ENVIRONMENT: The battery contains substances that may pollute the environment. Before discarding the hair trimmer, be sure to take out the battery or send the hair trimmer to the officially designated recycle bin to dispose of the battery. You can also send the waste hair trimmer to the company’s designated maintenance department, which will decompose and recycle the battery.

BATTERY REMOVAL: Cut off the power supply and let the hair trimmer run until the power is exhausted. Remove all the screws of the hair trimmer and the plastic parts, then take out the battery. Do not charge the battery after it is removed
CAUTION: The battery can only be removed when the hair trimmer is discarded

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>