GE APPLIANCES IND523 Lumination LED Luminaire Installation Guide
- June 4, 2024
- GE Appliances
Table of Contents
Lumination® LED Luminaire Diffuser Replacement
(RPL Series)
Installation Guide
IND523
IND523 Lumination LED Luminaire
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
RISK OF ELECTRIC SHOCK
- Turn the power off before inspection, installation or removal.
- Properly ground electrical enclosure.
RISK OF FIRE
- Follow all NEC and local codes.
- Use only UL-approved wire for input/output connections.
Only use size 18 AWG (0.75mm2).
Save These Instructions
Use only in the manner intended by the manufacturer. If you have any
questions, contact the manufacturer.
Tools and Components Required
| Description Code | Corresponding Luminaires |
|---|---|
| RPL22A Replacement diffuser | RPL22 series |
| RPL24A Replacement diffuser | RPL24 series |
Diffuser Replacement Steps
NOTE: The following steps depict the 22 Series luminaire. However, the procedure is the same for the 24 Series fixtures.
1. TURN OFF POWER at the source to the luminaire.| 2. Release latches on the
end of the fixture. Carefully pull down the fixture from the latch side.| 3.
Disconnect the quick connector for AC line and screw for ground wire. Then
carefully take down the fixture from the mounting bracket.
4. Remove the screws on the back of the housing which connected the housing
and front bezel.| 5. Carefully pull the housing from the front bezel.| 6.
Pull out the old diffuser.
7. Put the new diffuser on the front bezel.| 8. Fix all the screws on the
back of the housing which connect the housing and front bezel.| 9. Attach the
fixture to the LED panel bracket with the hinges. Hang the other end of the
tether to the installed bracket. Pull the tether lasso light.
Connect the LED driver to the AC line and install the grounding wire.
10. Secure the fixture by locking the latch found on the end of the fixture. Make sure wires and tether are on the back of the fixture.
These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be referred to GE Current a Daintree Company
www.gecurrent.com
© 2021 Current Lighting Solutions, LLC. All rights reserved. GE and the GE
monogram are trademarks of the
General Electric Company and are used under license. Information provided is
subject to change without
notice. All values are designed or typical values when measured under
laboratory conditions.
IND523 (Rev 04/02/2021)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>