RADWIN JET DUO 5.x 5.x GHz Dual Carrier 5.x GHz Base Station with Beamforming Antenna User Guide
- May 15, 2024
- RADWIN
Table of Contents
RADWIN JET DUO 5.x 5.x GHz Dual Carrier 5.x GHz Base Station with
Beamforming Antenna
Product Specifications
- Product Name: RADWIN JET DUO 5.x/5.x GHz
- Frequency: Dual Carrier 5. x GHz
- Antenna: Beamforming Antenna
- Certifications: FCC/ISED Compliance
- Antenna Types: Wide-angle and narrow-angle
- Antenna Manufacturer: RADWIN Ltd.
- Model Number : AP0200600
- Maximum Gain: 19 dBi @ 5.3-5.8 GHz
- Beamwidth: 80 degrees (wide angle), 18 degrees (narrow angle)
- Maximum Output Power: Total EIRP limited to 36 dBm
Product Usage Instructions
Regulatory Compliance
This device complies with FCC/ISED regulations. Any modifications should be
approved by the relevant authorities to ensure compliance.
Installation and Operation
- Ensure a minimum distance of 20 cm between the device and your body during installation and operation.
- The device operates in the 5.2 / 5.3 / 5.4 / 5.8 / 4.9 GHz bands under FCC Rules.
Usage Restrictions
The RADWIN JET DUO 5.x/5.x GHz is a proprietary device for professional
installers only. The firmware is locked and can only be controlled within
regional restrictions.
Antenna Configuration
- The antenna can be configured in wide-angle or narrow angle modes using software settings.
- Refer to the specifications for details on antenna gain, beamwidth, and output power.
FCC
FCC/ISED – Compliance
This equipment has been tested and found to comply with the limits for a Class
B digital device, under Part 15 of the FCC Rules and ISED RSS standards. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used by the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Caution: Outdoor units and antennas should be installed ONLY by experienced installation professionals who are familiar with local building and safety codes and, wherever applicable, are licensed by the appropriate government regulatory authorities. Failure to do so may void the product warranty and may expose the end user or the service provider to legal and financial liabilities. Resellers or distributors of this equipment are not liable for injury, damage or violation of regulations associated with the installation of outdoor units or antennas. The installer should configure the output power level of antennas according to country regulations and antenna type.
Warning: This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
This device complies with Part 15 of the FCC rules and with ISED license- exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference
that may cause undesired operation.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
Overview
The RADWIN JET DUO 5.x/5.x GHz is a dual carrier base station radio device
operating in the frequency range 4.9 – 5.8 GHz. It encapsulates two radio
modules as well as an independent beamforming antenna for each radio. The unit
is designed to deliver up to 2 x 1500Mbps. It supports 10, 20, 40 80 MHz
channel bandwidths in the frequency range 5150 – 5250 MHz, 5725 – 5850 MHz;
20, 40, 80 MHz in the frequency range 5250 – 5350 MHz, 5470 – 5725 MHz; 10,
20, 40 MHz channel bandwidths in the frequency range 4940 – 4990 MHz. It is
using OFDM transmission technique in the TDD Duplexing method.
The modulation supported is BPSK, QPSK, 16QAM, 64QAM, 256QAM OFDM
The RADWIN JET DUO 5.x/5.x GHz incorporates an independent beamforming antenna
for each radio with software capability to toggle between wide and narrow
beamwidth operating modes.
The RADWIN JET DUO 5.x/5.x GHz is powered by a PoE device and has a LAN port
option.
Only supported under FCC Rules
Condition of Use
The RADWIN JET DUO 5.x/5.x GHz is a proprietary radio device and can only be
deployed and maintained by RADWIN professional installers or its authorized
subcontractors
FCC Rules and ISED Regulation Restrictions
The ODU firmware is factory-programmed to operate under the FCC rules and ISED
regulation restrictions. The firmware is locked and inaccessible by any third
party. As a result of the above the user interface allows both the installer
and the user to control the ODU only within the boundaries of the regional
restrictions.
Antenna
The RADWIN JET DUO 5.x/5.x GHz is certified with a crossed dual pole
beamforming antenna type. The antenna is capable of operating in two modes
configurable by software: wide-angle and narrow-angle.
Certified Antenna
Following are the beamforming antenna configurations:
Antenna Type| Manufacturer| Model Number| Antenna Max Gain
(dBi)| Dir BW (deg)
---|---|---|---|---
Integrated| RADWIN Ltd.| AP0200600| 7 @ 4.9-5.2 GHz| 80
Integrated| RADWIN Ltd.| AP0200600| 9 @ 5.3-5.8 GHz| 80
Integrated| RADWIN Ltd.| AP0200600| 17 @ 4.9-5.2 GHz| 18
Integrated| RADWIN Ltd.| AP0200600| 19 @ 5.3-5.8 GHz| 19
Maximum Output Power
- 5725 – 5850 MHz band – FCC Part 15 Subpart E, ISED RSS 247
- The maximum output power can be set as follows, when operating in the 5.8 GHz band, under FCC 47 CFR Part 15.407 New Rules and ISED RSS-247 regulations.
- Total EIRP is limited to 36 dBm.
- The conducted output power in an 80deg configuration is 27 dBm.
- The conducted output power in the 19deg configuration is 17 dBm.
- 5150 – 5250 MHz band – FCC Part 15 Subpart E
- The maximum output power can be set as follows when transmitting in the 5.1 GHz band, under FCC 47 CFR Part 15.407 New Rules and Regulations.
- Total EIRP is limited to 36 dBm.
- The conducted output power in an 80deg configuration is 29 dBm.
- The conducted output power in the 18deg configuration is 19 dBm.
- 5250 – 5350 MHz band – FCC Part 15 Subpart E, ISED RSS 247
- The maximum output power is set as follows, under FCC and ISED regulations. Total EIRP is limited to 30 dBm.
- Conducted output power in 80deg configuration is 21 dBm.
- The conducted output power in the 19deg configuration is 11 dBm.
- 5470 – 5725 MHz band – FCC Part 15 Subpart E, ISED RSS 247
- The maximum output power is set as follows, under FCC and ISED regulations. Total EIRP is limited to 30 dBm.
- Conducted output power in 80deg configuration is 21 dBm.
- Conducted output power in 19deg configuration is 11 dBm
- 4940 – 4990 MHz band – FCC Part 90 Subpart Y, ISED RSS 111
- The maximum output power is set as follows, under FCC and ISED regulations
- Conducted output power in the 80deg configuration is 29 dBm and 36 dBm EIRP.
- The conducted output power in the 18deg configuration is 26 dBm and 43 dBm EIRP.
NOTE: The 40 MHz channel bandwidth is prohibited from use under ISED RSS-111
Radio parameters accessed by end-user
The following parameters can be accessed by the user:
- Output Power
- Frequency channel
- Channel bandwidth
RADWIN JET DUO 5.x/5.x GHz Reference Guide
FAQ
Frequently Asked Questions
- Q: Can this device be operated by non-professionals?
- A: No, the RADWIN JET DUO 5.x/5.x GHz is designed for professional installers or authorized subcontractors only.
- Q: What should be the minimum distance between the device and the user?
- A: Maintain a minimum distance of 20 cm between the device and your body during installation and operation as per regulatory guidelines.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>