Wooden Bunk Bed Harry Instruction Manual
- May 15, 2024
- HARRY
Table of Contents
Wooden Bunk Bed Harry Instruction Manual
Helpful advise before you begin:
- We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions.
- If you follow the instructions carefully the end result should be worth the effort.
- Do not discard any of the packaging until you have checked that you have all the parts and the pack of fittings
- Assemble this product on a carpet.
- To ensure an easier assembly, we strongly advise that all fittings are only finger tightened during initial assembly. Only upon completion of the assembly should all fixing points be fully tightened.
- We recommend a periodic check on all fixing points to make sure they remain fully tightened.
- Keep glue and fittings out of children’s reach.
- Do not use any other tools other than those recommended to build this product.
- Please do not use substitute parts. Use only additional or replacement parts supplied by supplier
- Check all bolts, screws and legs regularly to make sure they haven’t loosened and tighten all joins of your furniture or bedstead after 6 months.
- Storage Drawers in Bedsteads are designed to carry lightweight items such as Pillows, duvets and linen. Please try to avoid storing heavier items such as books or toys.
Do not discard any of the packaging until you have checked that you have all the parts and the pack of fittings.
Parts Checklist
- Lower Headboard (uniwersal – left/right) – 2 pcs.
- Leg (uniwersal – left/right) – 4 pcs.
- Element 1 (uniwersal – left/right) – 2 pcs.
- Element 2 (universal – left/right) – 2 pcs.
- Upper Headboard (universal – left/right) – 2 pcs.
- Leg (universal – left/right) – 4 pcs.
- Element 1 (universal – left/right) – 2 pcs.
- Element 2 (universal – left/right) – 2 pcs.
- Guardrail Lower -1 pcs
- Guardrail Upper -1 pcs
- Guardrail Upper / Lower -2 pcs
- Construction slats (support) – 8 pcs.
- Shorter side for ladder – 1 pcs
- Longer side for ladder – 1 pcs
- Steps for ladder – 4 pcs
- Rack boards (Flex) – 2x SET
- Front for drawer – 2 pcs
- Side for drawer – 4 pcs
- Read for drawer – 2 pcs
- Fibreboard – 4 pcs
- Rear windowsill – 2 pcs.
- Front upper windowsill -1 pcs.
- Front lower windwosill – 1 pcs.
There is a possibility of yellowing of the coating of white coloured beds.
Wood is a natural product, whose natural grain, texture and colour are subject
to fluctuations associated with growth, location and climate. Moreover, hue of
the wood surface varies over time as a result of light and heat.
This natural process of aging is subject to greater or lesser extent on all
types of wood. Wood is not resistant to light. Sunlight as well as diffused
light inside the room contribute the most to colour change. The degree of
changes to the shade depends not only on the passing of time, but also on
placement of the furniture. Invisible elements such as slats, frame supporting
the slats, bottoms of drawers, etc. are not painted as the rest of the bed.
All bolts and screws are to be screwed gently and slowly to avoid damaging the
panels by cracks. Do not screw fittings close to the edges.
ATTENTION! After assembling, please wipe the bed with a damp cloth. The
product might give off a strong scent of paint after assembling, usually up to
72hours.