RC4WD Z-R0013 Radio and Receiver for Miller Motorsports Pro Rock Racer User Guide

RC4WD Z-R0013 Radio and Receiver for Miller Motorsports Pro Rock Racer

Transmitter And Receiver Overview

Receiver and Servo Connection

Electric Powered Model

Gas Powered Model

Installing the Batteries

1. Remove the battery compartment cover.
2. Install four (4) new AA batteries.

Warning: Please replace batteries when the power indicator blinks or the buzzer beeps.

Binding the Transmitter and Receiver

1. Press the switch for more than 1 second, the LED light will flash.
2. Turn on the transmitter.
3. When the LED on the receiver becomes solid, the binding process is completed.

Failsafe Reminder

WARNING

After the connection procedure is completed, please turn off the transmitter and turn it on again, then the procedure will take effect, to confirm that the receiver is indeed connected to the transmitter normally and controlled by the transmitter. Do not perform connection procedures while the motor power wires are connected to the governor, or while the engine is running, as this could result in serious injury.

Transmitter Adjustments

Throttle Trigger

1. Push the trigger forward to slow down brake.
2. Pull the trigger backward to accelerate.

WARNING:

1. Keep the transmitter and receiver 40cm apart when operating.
2. Do not operate the radio system when the battery power is low.

Steering Wheel

• Turn the steering wheel to the left or right to let the vehicle turn left or right.

Operation Steps

1. Steering Control (CH1)
2. Forward / Backward / Brake (CH2)
3. Shift Gears (CH3)
4. Shift 2WD To 4WD (CH4)
5. Alternate Receiver Channel (CH5)
6. Lock and Unlock Diff Servo (CH6)
7. Power ON / OFF

First turn on the remote control (the switch or knob of the remote control should be in the default position), then connect the main car power supply, and wait for the signal sound to confirm before operation (about 5 Seconds). If you operate in advance, it is likely that the ESC will enter the settings. mode, resulting in the ESC not working properly.

WARNING:

• Operation of driveline servos should be done while at a stop.
• Damage may result from operating them while in motion. CH3, CH5, CH6.

Radio and Receiver for Miller Motorsports Pro Rock Racer.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>