Futaba T16IZ Air Transmitter User Manual

Futaba T16IZ Air Transmitter

Specifications

• Model: GYA553
• Software Version: GYA553 Software
• Compatibility: Compatible with various aircraft types
• Input Voltage: 4.8 – 6.0V
• Servo Type: Supports various servo types

By installing the latest software on the T16IZ/T16IZ SUPER, you can set the airplane gyro GYA553 on the T16IZ/T16IZ SUPER.

Connection

Connection T16IZ/T16IZ SUPER and GYA553

T16IZ/T16IZ SUPER

CAUTION
Be sure to connect and disconnect the GYA553 and Transmitter connection cable with the power off.

SETTING

Home screen

• On the home screen, basic information such as gyro operation mode, sensitivity, and battery voltage are displayed.

Basic menu

Confifig

Gyro set mounting direction

WING/TAIL

Set with the wing type/tail type of GYA553. The wing type/tail type of the transmitter is not used and is normal.

• Turn off the elevon/V-tail mixing on the transmitter side.
• Do not use transmitter sub-trim. Adjust using the gyro neutral offset.
• When using the S.BUS servo, you can also use the neutral offset function of the S.BUS servo setting parameters.

Servo type

• Select the servo type according to the servo to be used.
• Digital servo → DG : 285 Hz
• Analog servo → AN : 70 Hz
• The stability of the digital-servo mode of a flight increases to perform a high-speed control action.

SB/R2 OUT

Gyro direction

• It is the direction setting of the gyro. Be careful as it will crash if the direction is reversed.
• For dual aileron, dual elevator, and dual rudder aircraft, check the operating direction of each second aileron/elevator/rudder.

Neutral offset

Servo limit

• This is the limit setting for each servo. The position of the maximum operation is read into the gyro in the first setting.

• If the SB/R2 port output is set to “S.BUS(HS)” or “S.BUS(STD)”, the setting menu will display AIL3 and AIL4 setting items.
• AIL3 and AIL4 settings cannot be set with the button settings on the GYA553 main unit.

Aileron example

Holding Power

• It is a function to adjust the posture-holding force of the aircraft in AVCS mode.
• Decreasing the value weakens the holding power and makes the operation feel closer to the normal mode.
• The current rate numbers Cl to CS are displayed by operating the channel of the transmitter.
• Like the flight condition function of the transmitter, you can set up to 5 different data for the attitude holding force rate of the aircraft in AVCS mode by operating the switch from the transmitter and switching between them. You can set the holding power rate selector switch to the channel with the AFR function of the transmitter, and set the point for each rate on the AFR point curve to switch. It is also possible to use the flight condition function to work with the flight condition switch.

Reset

• Reset each Config item. It returns to the initial value.

SBUS Basic menu

Set the CH for each function according to the transmitter to be used. Any unused functions should be set to INH (Inhibited).

WARNING

Always verify that the S.BUS function assignments match your transmitter’s function (in the FUNCTION menu) assignments. If any changes are made within the transmitter function assignments, then it will also be necessary to make the changes within the S.BUS function assignments. To change the channel, GYA553 and T16IZ must be connected.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>