Futaba SBS-01T Temperature Sensor User Manual
- October 30, 2023
- Futaba
Table of Contents
Futaba SBS-01T Temperature Sensor User Manual
INSTRUCTION MANUAL
Thank you for purchasing Futaba’sSBS-OIT Temperature Sensor.
This sensor, used in conjunction with a telemetry enabled
transmitter/receiver, is used to indicate the operating temperatures of the
item to which it is attached.
To maximize your enjoyment, and to ensure proper sensing, please read through
this manual thoroughly. We also encourage you to retain the manual for future
reference should the need
WARNING
To utilize the SBS-01 T temperature sensor, connect it to the S.BUS2 port of
the Futaba telemetry enabled receivers. The SBS-01 Twill not function properly
if connected to an
S.BUS port or other channel ports. O Ensure that the unit is connected
properly to the receiver. Failure to do so could result in damage to the
sensor.
(S)To prevent any burns, always mount the SBS-01 T to the engine after it has
completely cooled.
(S)Do not use the SBS-01 T with anything other than an RIC model.
WARNING
-
The maximum operating temperature for the SBS-01 T is 200 °( . If used in applications that exceed the maximum operating temperature there is the risk of damaging the unit.
-
Ensure that the unit is mounted in an area that will eliminate exposure to fuel, water and vibration.
As with any electronic components, proper precautions are urged to prolong the life and increase the performance of the SBS-OlT. -
To ensure that the SBS-01 Tis functioning as desired, please test accordingly. Do not fly until inspection is complete.
-
Allow a slight amount of slack in the SBS-01T cables and fasten them at a suitable location to prevent any damage from vibration during flight.
Mounting Precautions
Please take care to ensure that the only portion of the temperature sensor
that touches the desired surface (cylinder head, motor can, etc.) is the
sensing unit itself as indicated in the image below.
To prevent damage, do not allow the remaining parts of the SBS-01 T to touch
the areas that will become hot.
LED Indication
Green-Normal operation Red-No signal reception
Green/Red-When setting up the slot
Green/Red Alternate blink –Unrecoverable error
Receiver connection/ Slot number setup
The SBS-01 T may only be used with telemetry enabled receivers that offer
S.BUS 2 port(s).
Please refer to the manual(s) that accompanied your transmitter and/or
receiver for proper connection methodology. Please note that the proper
default slot for this accessory is number one. Information on how to change
the slot assignment is included in the transmitter’s manual.
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>