HONK HK5011 USB Wireless Rechargeable Speaker Instructions

HONK HK5011 USB Wireless Rechargeable Speaker

Product Information

The device complies with part 15 of the FCC Rules, which means it meets the standards for electronic devices set by the Federal Communications Commission (FCC) in the United States. The device has been evaluated to meet general RF exposure requirements, which means it is safe to use in portable exposure conditions without restriction.

Product Usage Instructions

When using the device, please keep in mind the following:

• The device must not cause harmful interference.
• The device must accept any interference received, including interference that may cause undesired operation.
• Do not make any changes or modifications to the device that have not been expressly approved by the party responsible for compliance. Doing so could void your authority to operate the equipment.

By following these guidelines, you can safely and effectively use the device without any issues.

Product Diagram

How To Use

1. Please fully charge the product when it is used for the first time or after long-term storage. Please use USB interface adapter of 1A or above when charging.
2. lf the product is not used for a long time, it is recommended to  charge it every 3 months to avoid affecting the battery life.

PC Connection Method

Use the USB type-C cable to connect the speaker to the USB port of the computer. The computer system will automatically identify and install the driver for the first time. After the driver is installed successfully, there is usually a sound from the speaker at the same time (make sure that the computer is playing audio), if not, please check whether the computer’s sound playback device is USB Audio by default.
Take the win10 system as an example, click the small speaker in the lower right corner of the taskbar, a window will pop up, click the arrow in the upper right corner of the window, select USB Audio, and the setting is completed.

lndicator Light Status

Speaker lnd1cator(red) lnd1cator(Blue)

Charging| ON|
Full charging| OFF|
Wireless waiting for connection| | Quick flash(will turn off automatically if cannot connect in 10min)
Wireless or PC connected| | ON
Playing| | Slow flash

Button

Wireless Mode (us, ng mobile phone to search and connect BT _5011)

Long press(3s)| Turn on/off
Click on| Pause playback
Double click| Switch PC mode (connect usb cable with computer)
Three click| Disconnect the wireless link or initiate a connection back
Turn to left| Volume down
Turn to right| Volume up (play”didi”at maximum volume)
PC Mode (connect usb cable with computer)

Long press(3s)| turn on/off
Click on| Pause playback
Double click| Switch wireless mode
Turn to left| Volume down
Turn to right| Volume up (play “didi” at maximum volume)

Hint Tone

                                                     Hint Tone Speaker

Dodoo .. (Rising tone)| Turn on
Dodoo .. (Falling tone)| Turn off
Didi| Turn up the maximum volume
Dengdeng·| Low battery, please charge in time, otherwise it will automatically shut down

Product Parameter

Troubleshooting

1. The power cannot be on.
   Please confirm to turn the speaker on in the right way (press the switch for 3 seconds to turn on).

2. Shut down suddenly when using.
   Low battery, please charge in time.

3. The red indicator light is off when connecting usb cable.
   The battery is full and the product does not enter the charging state. The red indicator is off.

4. Double or three click is not workable

5. Please try again by pressing the button in quick succession. Usb cable connected, but cannot enter to PC mode. Please use the included 4-core usb cable, or make sure that you are not using an ordinary 2-core charging cable.

6. The battery cannot be fully charged after a long time Please use 5V lA adapter to charge.

Safety and notice

1. lt is forbidden to charge the product with a power supply exceeding 5V.
2. Please keep the speaker carefully in case of rain. And don’t put it next to the objects with high temperature or in the sun directly.
3. Non-professionals are forbidden to repair the duster or modify the circuit.

FCC Caution：

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>