TAKAYA IN-M-PAD Desktop Deactivator User Manual

Desktop Deactivator
MODEL IN-M-PAD
User Manual

Introduction

Thank you for purchasing our product.The Desktop Deactivator(IN-M-PAD) is the device that deactivates the tag(IN-M-AT/WI) by swiping over the antenna.
Parts Descrtiption

How to Use

1. Plug the AC adapter into the product. Environmental Requirements
   Please avoid the following placements.
   Place on or near the metal objects.
   Place within 2~3 meters around the security gate.
   *If mounting with the screws.
   Allow mounting to a wall by fixing the screw holes.
   Screws are not provided, should be self-supplied.
   Screw hole diameter：Φ4.5 ㎜
   Screw nominal diameter 4mm, length 12mm or more.
   Fix both sides of the screw holes to mount the device to the determined place.

2. Swipe the tag over the antenna.
   Safe removal of the tag is allowed after a “BLEEP” sound.
   ＊ Allow sounding tag removal.

• Do not apply excessive pressure, or shake, drop it.
• Do not expose to water or high humidity.
• Do not disassemble the device. It will cause failure or malfunction.
• Do not use an AC adapter other than the one supplied.

FCC Regulations

• This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

•  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
  If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
Changes or modifications not expressly approved by the manufacturer could void the user’ s authority to operate the equipment.
FCC RF Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. To comply with FCC RF Exposure compliance requirements, this grant is applicable to only Mobile Configurations. The antennas used for the transmitter must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
IC Notice
This device complies with Industry Canada’ s licence-exempt RSSs. Operation is subject to the following two conditions:

1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

IC Radiation Exposure statement
This device complies with Ic radiation exposure limits setforth foran uncontrolled environment .In order to avoidthe possibility of exceeding the lC radio frequency exposure limits ,human proximity to the antenna shall not be less than 20cm during normal operation.
CE Statement
This equipment complies with CE radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance of 20cm between the radiator and your body.
Here by,TAKAYA Corporation declares that the radio equipment type IN-M-PAD is in compliance with the Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address: 661-1 Ibara-cho,Ibara-shi,Okayama, Japan https://www.takaya.co.jp

CAUTION : RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Adapter : Adapter shall be installed near the equipment and shall be easily accessible.

References

• タカヤ株式会社

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>