3FT F0035 Fingerprint Drawer Lock User Manual

3FT F0035 Fingerprint Drawer Lock User Manual

USER’S MANYAL

F0035 Fingerprint Drawer Lock
‘Thank you for purchasing our products Please read carefully the manual before installation and use

Product parameters:

Name: Fingerprint Drawer Lock
Operating voltage: 3.3V ~ 4.2V, standby current. 30uA
Operating temperature: ~12°C = +68 C Number of user administrator users; 20 normal users

Warmly reminding:

Charging: during normal use, please charge the battery timely when the red light flashes. It can be charged by connecting to a normal Android interface charger. When charging normally, the red light keeps always on. When the battery is fully charged, the red light will turn off automatically. The charging time lasts for 15-20 minutes.

Installation instructions:

Fingerprint unlock:

1.  In the initial state, any fingerprint will unlock the system.
2. In the user—registered status, only the registered fingerprint can unlock the system.
3. When the fingerprint is correct, the areen light turns on.
4. When the fingerprint is wrong, the red light turns on.

Fing erPrInt entry method:

1. The first three registered fingerprints are regarded as administrator users, and subsequent fingerprints can
   only be registered with the verification of the first three fingerprints (administrator users).

2. Steps of initial registration (illustration)

(press and hold 5 seconds — press 5 times — press and hold 5 seconds — press 10 times —> success)

hold the fingerprint device for 5 seconds, the green light will flash, and then release the finger. Step 2: put
the finger to be registered on the fingerprint device, remove the finger until the biue light turns on, repeat this for 5 times, and the blue light will flash; step 3, press the fingerprint device with the same finger for 5 seconds, the green light wil flash, and repeats this for T0 times (each turning on of blue light indicates a successful press). the areen light’s keeping lighting up for 3 seconds means that the registration is successful.

Registered normal users (lllustration)

(Press and hold for 5 seconds —* Verify administrator users —> Press 10 times —> Success)

Registration of normal user: press the fingerprint device with the registered finger for 5 seconds, the biue
light will flash, and then release the finger. Verify the administrator fingerprint. If the verification is passed, the green light wii flash. Place the fingerprint to be registered on the fingerprint device and press it repeatedly for
10 times (each turning on of the blue light indicates one successful press). If the green light keeps lighting up for 3 seconds, the input Is successful. The subsequent fingerprint registration is completed following the above steps.

Restore factory settings (llustration)

en the red light will flash and release the finger. Press the fingerprint of administrator users (the first or second fingerprint registered ) to have the verification passed, and then the areen light will keep lighting on, which indicates that the factory settings have been restored.

The system will enter sleep automatically If no operation occurs within 10 seconds in the process of fingerprint input or verification.
Please replace another finger if the red light flashes twice when repeatedly Inputs the fingerprint. (3) Lights descripti

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>