TAC 240910 Side Steps Bars Installation Guide
- March 14, 2024
- TAC
Table of Contents
TAC 240910 Side Steps Bars Installation Guide
PROCEDURE:
- REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY.
- Remove the existing factory running boards or side steps, if equipped, by removing the hex nuts holding the mounting brackets to the inside of the body.
- Select (1) the driver side Mounting Bracket, (Figure 1).
Attach the Bracket to the front mounting location, with the included (2) 8mm Flat Washers, (2) 8mm Lock Washers and (2) 8mm Hex Nuts, **(Figure 2).
Do not tighten at this time. NOTE:** Slots in the top of the mounting brackets are off set. Use the illustration above to select the proper Mounting Bracket.
-
Repeat Step 3 for the driver side center and rear Mounting Bracket installation, (Figure 3).
-
Carefully place the driver Sidebar onto the (3) Mounting Brackets. Attach the Sidebar to the Brackets with the included (6) 8 x 25mm Combo Bolts. Do not tighten at this time.
-
Level and adjust the Sidebars as desired and tighten all hardware.
-
Repeat Steps 2—6 for passenger Sidebar installation.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight
To protect your investment, wax this product after installing. Regular
waxing is recommended to add a protective layer over the finish. Do not use
any type of polish or wax that may contain abrasives that could damage the
finish.
For stainless steel: Aluminum polish may be used to polish small
scratches and scuffs on the finish. Mild soap may be used also to clean the
Sidebar. For gloss black finishes: Mild soap may be used to clean the
Sidebar
Driver Side Installation Pictured
PARTS LIST:
| 1 | Driver/Left Side Bar | 12 | 8-1.25mm x 25mm Combo Bolts |
|---|---|---|---|
| 1 | Passenger/Right Side Bar | 12 | 8 x 24mm OD x 2mm Flat Washers |
| 3 | Driver/Left Side Mounting Brackets | 12 | 8mm Lock Washers |
| 3 | Passenger/Right Side Mounting Brackets | 12 | 8-1.25mm Hex Nuts |
Note offset upper mounting slots. Use illustration to determine correct Mounting Bracket
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>