FlexiSpot C-1388 Ergonomic Office Chair High Back Desk Chair Instruction Manual
- May 15, 2024
- FLEXISPOT
Table of Contents
C-1388 Ergonomic Office Chair High Back Desk Chair
Instruction Manual INSTRUCTION
MANUAL
Model: C-1388
ASSEMBLY GUIDE
Congratulations, you are now the owner of a brand new ergonomic chair!
To best enjoy the comfort of the chair, you have to put it together first!
This assembly guide will take you through the assembly process. To make sure
the assembly goes well, please follow the instructions, and especially the
important safety information.
It is possible to assemble the chair on your own, but it is recommended to
have a second person to make it easier and safer.
Please check if there are any missing parts from the package before starting.
If there is any issue, please don’t hesitate to drop us an email and we’ll
help you out ASAP.
If you run into any difficulty when assembling the chair, remember to check
out the assembly video to see if you’ve missed anything. If you’re unable to
resolve the problem, just send us an email and our support team will assist
you.
https://qygjuser.s3 .us-east-2.amazona ws.com/HL/6%E3%80%81OFC-1388F-1K-2.mp4
WARNING
To ensure proper assembly, please follow all steps and use all parts. Failure
to follow this warning can result in serious injury to yourself or others.
Package List
- Without further ado, we kindly suggest you to list all parts needed for the chair first.
Assembly Instruction
-
Step 1: Turn the Base (14) upside down, and then insert the Legs (6) one by one into the Base.
Next, screw ten Bolts (13) into the pre-drilled holes with the Wrench (15) to attach the base and the legs. -
Step 2:
Press the Casters (7) into the holes at the end of each Base Leg. -
Step 3:
And then insert the Gas Lift (5) to the base. -
Step 4: Turn the Seat (2) upside down and align three holes on one of the Armrests (3) with the pre-drilled holes under the Seat.Attach the Armrest to the Seat with three Bolts (10) using the rench (15). Repeat on the other side of the armrest. Note 1: The same marks on both seat and armrests are tips for installing the armrests in the correct direction.
Note 2: Armrests are labeled with letter “L” (left) or “R” (right). -
Step 5: Align the mechanism (4) over the pre-drilled holes underneath the Seat (2), make sure the front of the mechanism is facing the front of the Seat. Attach the mechanism to the Seat with four Bolts (8), and tighten all bolts with the Wrench (15).
*Be cautious as mis-threading the bolts will damage the seat. -
Step 6:
Turn the Back (1) upright and attach the seat while aligning three holes of the Mechanism (4). Attach three Bolts (9)with the Wrench. -
Step 7:
Align the hole at bottom of the seat with the Gas Lift, put the body of the chair on the Gas Lift.
Fix the Headrest (11) on top of the chair by attaching two Bolts (12).
CAUTION:
Make sure all bolts and screws are fully tightened before using chair.
Lubricate all moving parts and tighten all bolts/screws every 6 months or
whenever needed.
Instructions For Use
- Seat Height: Paddle-shaped lever on the right side To raise: While taking your weight off chair, lift lever up.
To lower: While seated, lift lever up.
- At the proper height, your feet should rest flat on the floor.
2. Tilt Tension: Long stem under the seat with knob To increase tension: While seated, turn knob forward (Counterclockwise).
To decrease tension: While seated, turn knob backward (Clockwise ). - Set the tilt tension to control the resistance you feel when leaning back.
3. Operating the tilt lockout Push the lever inwards, it locks the tilting.
Pull the lever outwards, it unlocks the tilting. - In order for it to tilt you need to lean back in the chair until you hear a click, now you can freely move it. Then push the lever inwards again to lock it where you want it.
4. Armrests adjustmentPress the button on the middle of the arms to slide the armrests up and down.
The top of the arms goes forward and back. Can also rotate 20°
Safety And Maintenance
- Do not stand on the chair, Do not use the chair as a stepladder.
- Use this product for seating one person at a time.
- Do not use the chair unless all bolts and screws are firmly secured.
- Avoid contact with sharp objects to prevent puncturing the fabric.
- Every 6 months, check all bolts and screws to ensure they are tight.
- To clean, spot clean only using a damp towel and mild cleaner, first test on a small, unseen area of fabric.
- Chair weight limit not to exceed 300 lbs.
Safety Information
| | |
---|---|---|---
Sit in the center of the chair, with your back to the backrest| Do not sit at
the front edge of the chair| Do not stand on the chair| Do not use the chair
with more than one
person
| | |
Do not push the chair around when a person is sitting in it| Do not push down
on the backrest when a person is reclined| Do not place all your weight on
only the
backrest|
Limited Warranty
The producer promises to repair or replace any chair that is found to be
defective in material or workmanship within one(1) and year from the date of
original purchase so long as you, the original purchaser, still owns it.
This is your sole and exclusive remedy. This warranty is subject to the
provisions below.
EXCLUSIONS:
This warranty does not apply and no other warranty applies to:
- Normal wear and tear, which are to be expected over the course of ownership.
- Misuse, abuse, or excessive use of the product.
- Modifications or attachments to the product that are not approved by the manufacturer.
- Products that were not installed, used or maintained in accordance with product instructions and warnings.
- Products used for rental or commercial purposes.
- Damage caused by the carrier in-transit is handled under separate terms.
SEATING USAGE:
Normal use for seating is identified as the equivalent of a single shift,
forty- (40) hour workweek. To the extent that a seating product is used in a
manner exceeding this, the applicable warranty period will be reduced in a
pro-rata manner.
Some retailers might have custom models imported directly from the factory and
therefore are not supported by our local service team because we don’t have
the correct parts, please contact your retailer directly for support. If you
have any questions about that we will be happy to assist and identify those
items.
RETURN POLICY:
We adopt a 30 days return policy which means that all products purchased on
this website may be returned to us within the timeframe. You need to contact
us within 30 days after the product(s) came into your possession and the
product(s) must be returned to us without any undue delays.
Returned products must be returned in the same condition as they were sent and
they must be sent in its original packaging.
If the product is not faulty, (i.e. if you changed your mind or if you are
unhappy with the product for some other reason), the cost of shipping will all
on you. And it is your responsibility that the package arrives safely to us so
we recommend that you use a courier service where it is possible to track the
shipment.
If the product is faulty when you receive it please contact us and we will
help you out (see more information under Manufacturer Warranty).
We reserve the right to give a partial refund in cases when the product(s) is
not in an unused condition, is damaged or has missing parts not due to our
error.
HOW RETURNS WORK:
Contact us through the contact form on our website and attach the invoice to
the message as proof of purchase. And please also write the reason for the
return.
We will then get back to you as soon as possible with information on where to
send the product(s).
As soon as we have received the product(s) and made an inspection we will
inform you of our decision.
If a refund is approved we will automatically credit the purchase to your
credit card or original method of payment.
If the product(s) is damaged, not in its original condition or missing parts
we will inform you if you are eligible for a partial refund. This is decided
from case to case depending on the severity of the damages or what parts are
missing.
HJ-Customer-Service@outlook.com
(909)637-7665 | (909)637-7593
EST 9:00AM–17:00PM