SHADA DBL-02 LED Spotlight Installation Guide
- May 15, 2024
- SHADA
Table of Contents
SHADA DBL-02 LED Spotlight
Dimension
Installation
Replacing LED unit
Replace the LED module with qualified personnel only.
Safety warning!
Ensure that you have fully read and understood the instructions in this document before you install or use the product following the installation/wire diagram (when applicable). Keep this document for future reference and only use the product as described in this document. Any other use of the product than described in this manual may damage the product or cause injury to the user (e.g. due to a short circuit, fire or electric shock). Disconnect the product from the power source when problems occur. Do not drop the product and avoid bumping. Do not use the product if a part is damaged or defective.
Replace a damaged defective product immediately. When a non-standard consumer (power )installation is required this should be performed by a qualified technician to reduce the risk of an electric shock. Make sure the product is sufficiently ventilated during use. Never cover an electrical (LED) device during usage since it can generate heat causing damage. Besides LED can be extremely bright and may cause serious eye damage so do not stare at it directly. When a product is meant for indoor and/or outdoor use only, this will be mentioned on the product/parts or in the manual. Keep the product out of reach of children or animals.
Cleaning and Maintenance Warning!
Do not use cleaning solvents or abrasives. Do not clean the inside of the device. Do not attempt to repair the device. Replace the device when it does not operate correctly. Clean the outside of the device using a soft, damp cloth (Do not use a microfiber cloth)
Support
If you need further help or have comments or suggestions please visit:
www.shada.nl/n|/contact
- Caution! Risk of electric shock.
- A cover with damage must be replaced.
- Non dimmable.
- IP44 Enclosure – IP rated as “protected against solid objects that are bigger than 1mm and water splashing from all directions.
- tem from household waste, you will help reduce the volume of waste sent to incinerators or landfills.
- By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or landfills and minimize any potential negative impact on humans.
- This product carries the CE mark, which confirms that this product meets EU safety, health and environmental protection requirements.
- Class I – the metal parts in these devices are connected to the electrical earth. The current will flow in the earth conductor in case of failure.
- Do not stare at the light source.
- Non-replaceable control gear.
- Replaceable light source.
- Minimum distance to illuminated objects.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>