INDESIT IAHTT64FLSK 60cm Cooker Hood Instruction Manual

INDESIT IAHTT64FLSK 60cm Cooker Hood

Specifications:

• Height (cm): 18
• Width (cm): 59.8

Product Information

General Safety:
The appliance is not designed for professional use and should not be operated using an external device or separate remote control system. It is not intended for outdoor use. To prevent personal injury, the appliance should be handled and installed by at least two people.

Appearance:
The appliance may have different aesthetic features than those illustrated in the manual, but the operating, maintenance, and installation instructions remain the same.

Mains Voltage and Frequency:
Refer to the values indicated on the rating plate inside the hood for voltage and wire connection instructions.

Air Outlet:
The evacuation pipe is not included and must be purchased separately. Ensure the diameter of the exhaust pipe matches the connecting ring. For filtration versions, carbon filters need to be removed.

Controls:
The hood is equipped with a control panel featuring suction speed control and light control for the hob illumination.

Product Usage Instructions

Installation:
Follow the installation instructions provided in the manual. Ensure proper wire connections as indicated (yellow/green for ground, blue for neutral, brown for live).

Maintenance:
Clean the hood regularly using a damp cloth with neutral liquid detergent. Do not use abrasive tools or cleaners. Replace carbon filters as needed according to the manual’s instructions.

Disposal:
Dispose of the appliance in accordance with local regulations and guidelines for end-of-life products.

Anomalies and Troubleshooting:
If you encounter any operational issues, disconnect the appliance from power for at least 5 seconds before reconnecting. If problems persist, contact customer service for assistance.

FAQ:

1. Q: Can this appliance be used outdoors?
   A: No, the appliance is not intended for outdoor use.

2. Q: What should I do if there are operational anomalies?
   A: Disconnect the appliance from power for at least 5 seconds and reconnect. If issues persist, contact customer service for assistance.

Hardware

Mounting

GENERAL SAFETY

• Do not make electrical or mechanical changes on the product or on the exhaust pipes.
• Before doing any cleaning or maintenance work, disconnect the product from the mains power supply by removing the plug or turning off the mains switch.
• For all installation and maintenance operations, always wear work gloves.
• The product can be used by children over the age of 8 and by people with reduced physical, sensory or mental capabilities or without experience or the necessary knowledge, as long as they are properly supervised or have been instructed on how to safely use the device and understand the inherent dangers.
• Children must be supervised to make sure that they do not play with the product.
• Cleaning and maintenance must never be performed by children unless they are properly supervised.
• The room must have sufficient ventilation when the product is used at the same time as other appliances burning gas or other fuels.
• The product must be cleaned frequently both inside and out (AT LEAST ONCE A MONTH); always follow the instructions given in the maintenance manual.
• Failure to comply with the rules indicated for cleaning the product and replacing/cleaning the filters may result in the risk of fire.
• It is strictly forbidden to cook food on the flame under the product.
• WARNING:
• When the hob is on, the accessible parts of the product may become hot.
• Do not connect the product to the electrical power supply until the installation is complete.
• The regulations laid down by local authorities must be strictly followed with regard to the technical and safety measures to adopt for fume extraction.
• The extracted air must not be conveyed through the same ducts used to extract the fumes generated by gas combustion or other types of combustion products.
• Do not use or leave the product without appropriately installed lamps, as this may result in the risk of electric shock.
• The product must NEVER be used without the grille correctly fitted.
• The product must NEVER be used as a support surface unless expressly indicated.
• Range hoods and other cooking fume extractors may adversely affect the safe operation of appliances burning gas or other fuels (including those in other rooms) due to back flow of combustion gases. These gases can potentially result in carbon monoxide poisoning.
• After installation of a range hood or other cooking fume extractor, the operation of flued gas appliances should be tested by a competent person to ensure that back flow of combustion gases does not occur.
• Use only the fastening screws supplied with the product for its installation, or if not supplied, purchase the correct type of screws.
• Use screws of the right length, as indicated in the installation guide.
• Please note! Failure to install screws and fasteners in accordance with these instructions may result in electrical hazards.
• To replace the lamp, only use the lamp indicated in the maintenance/lighting system section of this manual.
• Using a naked flame may damage the filters and cause a fire hazard, and must therefore be avoided under all circumstances.
• Extra care must be taken when frying to prevent the oil from overheating and catching fire.
• In case of doubt, contact the authorized service centre or similar qualified personnel.
• Please note! Do not use with a programmer, timer, separate remote control or any other device that activates automatically.
• The minimum distance between the container support surface on the cooker and the lower part of the hood must be at least equal to 50 cm (not less than 65 cm only for Australia and New Zealand) in case of electric cookers and to 65 cm in case of gas or mixed cookers.
• If the installation instructions of the gas cooker specify a greater distance, take it into account.
• Keep children under the age of 3 away from the appliance.
• Without the constant supervision of an adult, keep the appliance out of the reach of children under the age of 8.

ATTENTION: the appliance is not designed to be operated using an external device or a separate remote control system.

• This appliance is not intended for professional use. Do not use the appliance outdoors.
• To avoid the risk of personal injury, the appliance must be handled and installed by two or more people.
• Installation operations, including any water supply connections (if any) and the electrical connections, and repairs must be carried out by qualified personnel.
• When installation is complete, keep the packaging material (plastic parts, polystyrene, etc.) out of the reach of children to avoid the risk of suffocation.
• Do not use the appliance when barefoot or wet.
• Never use steam cleaning appliances – risk of electric shock.
• Strictly observe the instructions in this manual. All liability is declined for any problems, damage or fires caused by failure to comply with the instructions in this manual. The device is intended for domestic use only, to cook food and extract the fumes generated by cooking. No other use is allowed (e.g. heating rooms). The manufacturer declines any liability for inappropriate use or incorrect control settings.
• Read the instructions carefully: they contain important information on installation, operation and safety.
• Do not make electrical changes to the device.
• Before installing the device, make sure that none of the components are damaged. Otherwise, contact the dealer and do not continue with the installation.
• It is important to keep all the manuals accompanying the product so that they can be consulted at all times. If sold, transferred or moved, make sure it remains with the product.

The device may have different aesthetic features with respect to the illustrations in this handbook, however the operating, maintenance and installation instructions remain the same.

ELECTRICAL CONNECTION
The mains voltage must correspond to the voltage indicated on the rating plate located inside the hood. If equipped with a plug, connect the hood to a wall socket that complies with current standards located in an area that can be accessed even after installation. If it does not feature a plug (direct connection to the mains) or the plug is not located in an accessible area, even after installation, apply a standard double pole switch that ensures complete disconnection from the mains in category III overvoltage conditions, in accordance with the installation rules.
Please note: Before reconnecting the circuit to the mains power supply, make sure that it is working correctly, always check that the power cable is correctly installed.
Do not use extension cords, power strips or adapters.

If the cable is not fitted with a plug, connect the wires according to the following table:
Mains voltage and frequency
Refer to the value indicated on the rating plate inside the hood.

Wire connection

• : yellow/green
• N: blue
• L: brown

Replacing the power cable
The hood features a special power cable; if the cable is damaged, contact the Service Centre for a replacement.

AIR OUTLET

(for suction versions)
Connect the hood to wall-mounted exhaust pipes and holes with a diameter equivalent to the air outlet (connecting flange). The use of pipes and outlet holes in the wall with a smaller diameter will reduce the extraction performance and drastically increase the noise level. All responsibility in this regard is therefore denied.

• Use a ducting pipe with the shortest length necessary.
• Use a ducting pipe with the least number of bends possible (maximum bend angle: 90°).
• Avoid drastic changes in the ducting pipe diameter.
• The company shall not be held responsible if these regulations are not complied with.

FILTRATION OR SUCTION?
Your hood is read to be used in the suction version. To use the hood in the filtration version, the special ACCESSORY KIT must be installed. Check, on the first pages of this manual, whether the ACCESSORY KIT is already supplied or needs to be purchased separately.
Note: If supplied, in some cases, the additional activated carbon filtering system may already be installed on the hood. Information on how to convert the hood from the suction version to the filtration version is already contained in this manual. Extraction version
Vapours are evacuated outside through an exhaust pipe attached to the connecting flange.

ATTENTION
The evacuation pipe is not supplied and must be purchased.
The diameter of the exhaust pipe must be equivalent to the diameter of the connecting ring. If the hood features one or more carbon filters, they must be removed.

Filtration version
The suctioned air will be degreased and deodorised before it is sent back into the room. To use the hood in this version, it is necessary to install an additional activated carbon filter system.

CONTROLS

The hood is equipped with a control panel with a suction speed control and a light control to light up the hob.

• a. ON/OFF light switch
• b. Speed 1/OFF switch
• c. 2-speed selection
• d. 3-speed selection

MAINTENANCE

Cleaning: For cleaning, simply use a cloth moistened with neutral liquid detergents. Do not use cleaning tools or instruments.
Anti-Grease Filter: It must be cleaned once a month (or when the filter saturation indication system – if any – indicates the need for it), with non- aggressive detergents, either by hand or in a dishwasher at a low temperature and on a short cycle.
When cleaned in the dishwasher, the metal grease filter may discolour, but its filtering characteristics remain unchanged.

• The Anti-Grease Filter traps the grease particles produced during cooking. When cleaned in the dishwasher, the metal grease filter may discolour, but its filtering characteristics remain unchanged.
• To remove the anti-grease filter, pull the spring release handle.

Carbon filter (for filter version only): The cartridge must be replaced at least every four months. It CANNOT be washed or regenerated. As indicated in the drawings section: remove the anti-grease filters, apply a carbon filter on each side and attach it to the product. Put the anti-grease filters back in place.

• The carbon filter retains any unpleasant odours produced during cooking.
• The saturation of the carbon filter can occur after somewhat prolonged use depending on the type of cooking and how regularly the grease filter is cleaned.

Illumination
Lamp Replacement : Disconnect the product from the electrical power supply. Please note! Before touching the lamps, make sure they have cooled. For the type of lamp to use, see the indications in the drawings section.

END-OF-LIFE DISPOSAL
This device is marked in compliance with the European Directive 2012/19/EC – UK SI 2013 No.3113, Waste Elec-trical and Electronic Equipment (WEEE).
Make sure that this product is disposed of correctly. The user helps prevent potential negative consequences for the environment and for health. The symbol on the product or accompanying documentation indicates that this product should not be treated as household waste but should be handed over at a suitable collection point for the recycling of electrical and electronic equipment. Dispose of it in accordance with local regulations for waste disposal. For further information about the treatment, recovery and recycling of this product, please contact your local authority, the collection service for household waste or the shop from where the product was purchased.
The packaging material is 100% recyclable and is marked by the recycling symbol

REGULATIONS
Equipment designed, tested and manufactured in compliance with safety regulations: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233. Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO 5168; EN/IEC 60704-1; EN/IEC 60704-2-13;EN/IEC 60704-3; ISO 3741; EN 50564; IEC 62301. EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2; EN/IEC 61000-3-2; EN/IEC 61000-3-3.

RECOMMENDATIONS FOR USE
Recommendations for correct use in order to reduce the impact on the environment: When cooking begins, the device should be turned on at minimum speed, and left on for a few minutes even after cooking is complete. Increase the speed only if there is a large quantity of fumes and steam, using the Booster function only in extreme cases. To keep the odour reduction system running efficiently, replace the carbon filter/s when necessary. To ensure the high performance of the grease filter, clean it when necessary. To improve efficiency and minimise noise, use the maximum duct diameter indicated in this manual.

OPERATING ERRORS

If something does not seem to be working, perform the following simple checks before contacting the Service Centre:

If the hood is not working:
Check that:

• There is no power failure
• A speed has been selected
• If the hood has poor performance:

Check that:

• The selected motor speed is sufficient for the amount of fumes and steam released.
• The kitchen is sufficiently ventilated to allow an air intake.
• The carbon filter is not worn out (hood in filtration version).
• If the hood has switched off during normal operation:

Check that:

• There is no power failure.
• The safety cut-off device has not tripped.

In the event of any malfunctions, disconnect the appliance from the electrical power supply for at least 5 seconds by unplugging it and then reconnect it, before contacting the Service Centre. If the malfunction persists, contact the Service Centre.

TECHNICAL SPECIFICATIONS

Components not supplied with product

To download the safety instructions, user manual, technical data sheet and energy data:

• Visit the website docs.indesit.eu
• Use the QR code
• Alternatively, contact Customer Service (using the phone number indicated on the warranty booklet). When contacting Customer Service, communicate the codes on the product rating plate.

References

• Whirlpool Docs

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>