WIE127 Automatic Washing Machine

Product Information: Washing Machine

The WIE 127 is a washing machine designed to clean clothes
efficiently. It has various features that allow users to customize
their washing experience, such as setting the spin cycle, delay
timer, and temperature. The control panel has a display that shows
information regarding the washing cycle. The machine also has a
detergent dispenser and a bleach cycle. It is important to read the
instruction manual carefully to ensure proper installation, use,
and safety.

Installation

It is recommended to keep the instruction manual in a safe place
for future reference. Upon unpacking, check if the washing machine
has been damaged during transport. Remove the protective screws and
rubber bush with the respective spacer situated on the rear of the
appliance. Seal all gaps using the plastic plugs provided. Install
the washing machine on a flat sturdy floor without resting it up
against walls, furniture cabinets, or others. Levelling the
appliance correctly will provide stability and avoid any
vibrations, noise, and shifting during operation. Connect the water
inlet hose to the washing machine’s cold water inlet, ensuring
there are no kinks or bends in the hose.

Usage Instructions

Starting and Programmes

To start a programme, refer to the programme table in the
instruction manual. Press the corresponding button on the control
panel to select the desired programme. The display will show
information regarding the selected programme. Press start to begin
the washing cycle.

Personalizations

The WIE 127 allows users to customize their washing experience
by setting the spin cycle, delay timer, temperature, and functions.
Use the corresponding buttons on the control panel to adjust these
settings according to your preference.

Detergents and Laundry

The machine has a detergent dispenser and a bleach cycle. Ensure
to prepare your laundry and use the appropriate detergent according
to the instruction manual. Follow the Woolmark instructions for
washing woolen items.

Care and Maintenance

It is important to cut off the water or electricity supply
before cleaning the appliance. Regularly clean the appliance,
detergent dispenser, door and drum, and pump to ensure optimal
performance. Check the water inlet hose for any damages.

Troubleshooting

If you encounter any issues with the washing machine, refer to
the troubleshooting section in the instruction manual. If you
require service, contact the manufacturer or retailer.

Instructions for use

WASHING MACHINE

GB
English, 1
WIE 127

Contents
GB
Installation, 2-3-4-5
Unpacking and levelling, 2 Electric and water connections, 2-3 The first wash cycle, 4 Technical details, 5
Washing machine description, 6-7
Control panel, 6 Display, 7 MEMO Programme, 7
Starting and Programmes, 8
Briefly: how to start a programme, 8 Programme table, 8
Personalisations, 9
Setting the spin cycle, 9 Setting the Delay Timer, 9 Setting the temperature, 9 Functions, 9
Detergents and laundry, 10
Detergent dispenser, 10 Bleach cycle, 10 Preparing your laundry, 10 Special items, 10 Woolmark, 10
Precautions and advice, 11
General safety, 11 Disposal, 11 Saving energy and respecting the environment, 11
Care and maintenance, 12
Cutting off the water or electricity supply, 12 Cleaning your appliance, 12 Cleaning the detergent dispenser, 12 Caring for your appliance door and drum, 12 Cleaning the pump, 12 Checking the water inlet hose, 12
Troubleshooting, 13
Service, 14
Before calling for Assistance, 14

1

Installation

Keep this instruction manual in a safe place for GB future reference. Should the appliance be sold,
transferred or moved, make sure the instruction manual accompanies the washing machine to inform the new owner as to its operation and features.
Read these instructions carefully: they contain vital
information on installation, use and safety.
Unpacking and levelling
Unpacking
1. Unpack the washing machine. 2. Check whether the washing machine has been damaged during transport. If this is the case, do not install it and contact your retailer.
3. Remove the 3 protective screws and the rubber bush with the respective spacer, situated on the rear of the appliance (see also the installation leaflet). NB:The plastic spacers may fall down inside the machine once the bolt has been removed, and will not interfere with the operation of the machine.
4. Seal the gaps using the plastic plugs provided. 5. Keep all the parts: you will need them again if the washing machine needs to be moved to another location.
Packaging materials are not children’s toys.
Levelling
Your machine may make a considerable amount of noise if the two front feet have not been adjusted correctly. 1. Install the washing machine on a flat sturdy floor, without resting it up against walls, furniture cabinets or other.
2. If the floor is not perfectly level, compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured according to the worktop, must not exceed 2°.

Levelling your appliance correctly will provide it with stability and avoid any vibrations, noise and shifting during operation. If it is placed on a fitted or loose carpet, adjust the feet in such a way as to allow enough room for ventilation beneath the washing machine.

Electric and water connections

Connecting the water inlet hose

1. Insert seal A into the

end of the inlet hose

and screw the latter

onto a cold water tap

with a 3/4 gas threaded

A

mouth (see figure).

Before making the

connection, allow the

water to run freely until

it is perfectly clear.

2. Connect the other end of the water inlet hose to the washing machine, screwing it onto the appliance’s cold water inlet, situated on the top right- hand side on the rear of the appliance (see figure).

3. Make sure there are no kinks or bends in the hose.
The water pressure at the tap must be within the
values indicated in the Technical details table (on the next page).
If the water inlet hose is not long enough, contact
a specialist store or an authorised serviceman.
Ensure that the supply taps are allowing water
through. Old taps may seize in the closed position and thus prevent water reaching the machine.

2

Connecting the drain hose

65 – 100 cm

Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor;

Where it connects to the waste water pipe cut end off spigot or remove the blanking cap

The drain hose may be connected to an under-sink trap. Before connecting the drain hose from the machine ensure that any blanks or removable ends have been taken off the spigot.
If it is place over the edge of a basin or sink be sure the free end of the hose should not be underwater.

We advise against the use of hose extensions; in
case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150 cm in length. Ensure that if the drain hose is pushed into a standpipe, that the end does not go down more than 15cms (6 inches). If the hose is pushed down too far, this may cause the machine to self -syphon ie. continuously empty as it is filling.
Electric connection
Before plugging the appliance into the mains socket, make sure that:
the socket is earthed and in compliance with the applicable law;
the socket is able to sustain the appliance’s maximum power load indicated in the Technical details table (see page 5);

the supply voltage is included within the values i

ndicated on the Technical details table

GB

(see page 5);

Installation

the socket is compatible with the washing machine’s plug. If this is not the case, replace the socket or the plug.

Description

Your appliance is now supplied with a 13 amp fused plug it can be plugged into a 13 amp socket for immediate use. Before using the appliance please read the instructions below.

WARNING – THIS APPLIANCE MUST BE EARTHED. THE FOLLOWING OPERATIONS SHOULD BE CARRIED OUT BY A QUALIFIED ELECTRICIAN.

Programmes

Replacing the fuse: When replacing a faulty fuse, a 13 amp ASTA approved fuse to BS 1362 should always be used, and the fuse cover re-fitted. If the fuse cover is lost, the plug must not be used until a replacement is obtained. Replacement fuse covers: If a replacement fuse cover is fitted, it must be of the correct colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot.

Detergents

Precautions

Removing the plug: If your appliance has a non-rewireable moulded plug and you should wish to re-route the mains cable through partitions, units etc., please ensure that either: the plug is replaced by a fused 13 ampere rewearable plug bearing the BSI mark of approval. or: the mains cable is wired directly into a 13 amp cable outlet, controlled by a switch, (in compliance with BS 5733) which is accessible without moving the appliance.

Care

Troubleshooting

Disposing of the plug: Ensure that before disposing of the plug itself, you make the pins unusable so that it cannot be accidentally inserted into a socket.

Instructions for connecting cable to an alternative plug:

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow Earth

Blue

Neutral

Brown

Live

Service

3

Obsah je uzamcen
Dokoncete, prosím, proces objednávky. Následn budete mít pístup k celému dokumentu.
Proc je dokument uzamcen? Nahnvat Vás rozhodn nechceme. Jsou k tomu dva hlavní dvody: 1) Vytvoit a udrzovat obsáhlou databázi návod stojí nejen spoustu úsilí a casu, ale i financní prostedky.
Dlali byste to Vy zadarmo? Ne. Zakoupením této sluzby obdrzíte úplný návod a podpoíte provoz a rozvoj nasich stránek. Teba se Vám to bude jest nkdy hodit. ) Mozná zpocátku ano. Ale vzte, ze dotovat to dlouhodob nelze. A rozhodn na tom nezbohatneme. 2) Pak jsou tady ,,roboti”, kteí se pizivují na nasí práci a ,,vysávají” výsledky naseho úsilí pro svj prospch. Tímto krokem se jim to snazíme pekazit. A pokud nemáte zájem, respektujeme to. Urgujte svého prodejce. A kdyz neuspjete, rádi Vás uvidíme!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>