GAIZERL 800GPH Pool Cover Pump User Manual

Automatic Pool Cover Pump

Thank you for purchasing our pool cover pump. Please read the instruction manual carefully before using this product.

PRODUCT SPECIFICATIONS

Garden Hose Adapter 1/ Fastener1/ Filter Sponge *2

PRODUCT FEATURES

1. This product has a water shortage protection function, designed for automatic removal of water from pool covers. The pump will automatically work when the water level above 0.7inch, and automatically shut off when water drops to 0.7inch.
2. With a 1 inch garden hose adapter, can fit standard 1 inch garden hose.
3. The product adopts DC 24V low voltage adapter, safe and worry-free.
4. In order to drain the water, the pump will continue to operate for 5 seconds after no water is detected.
5. With 49.2ft power cord, 11.48ft head, this pump can be widely used in swimming pool covers, fish tanks, bathtubs, basements, small ponds, boat barns or roofs, etc.

STEPS TO INSTALL THE PUMP

1. Connect the power cord and adapter.
2. Twist hose adapter to water outlet until it locks.
3. Install the hose to hose adapter, and secure it with the fastener.
4. Connect the power supply.
5. When the pump is completely submerged, it will work automatically.
   

CARE AND MAINTENANCE PUMP

• Always disconnect the pump before cleaning.
• Clean the pump when it is visibly soiled or when a drop in performance is detected.
• The pump needs to be cleaned periodically.

Steps to cleaning the pump:

1. Turn the back cover in the direction of unlocking, unscrew the back cover lock ①.
2. Remove the bottom cover of the pump ②, filter sponge ③ and the rotor access cover ④.
3. Take out the rotor assembly ⑤.
4. Clean the filter sponge (replaceable) and rotor.
   Please note that the Gasket ( a ) and Shaft Sleeve ( b ) on the rotor assembly cannot be lost.

WARNINGS

1. Keep the power cord away from high temperatures or other heat sources.
2. Do not use this pump to drain the water if there are people in the water.
3. Always disconnect the electrical power before cleaning the pump.

TROUBLESHOOTING

If the pump fails to operate:

• Check to make sure the power cord is plugged in, the pump is getting power and the pump is fully submerged.
• Check pump outlet and hose for blockage.
• Clean the filter sponge and rotor.

If the performance of the pump is not satisfactory or the pump does not flow evenly:

• Check to make sure the pump is completely submerged in water.
• Check to make sure the filter sponge, rotor, water sensor and the shell are clean.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>