GAIZERL Automatic Pool Cover Pump Instructions

Table of Contents

Thank you for purchasing our pool cover pump. Please read the instruction manual carefully before using this product.

$GAIZERL-Automatic-Pool-Cover-Pump-fig- $2$$

This product has a water shortage protection function, designed for the automatic removal of water from pool covers.
The pump will automatically work when the water level is above 0.7inch, and automatically shut off when water drops to 0.7inch.
With 3/4 inch and 1/2 inch garden hose adapters, can fit standard 3/4 and 1/2 garden hose.
The product adopts a DC 24 V low-voltage adapter, safe and worry-free.
The 3/4-inch hose couplings are equipped with a non-return valve, which can effectively prevent the backflow of water.
With a 49.2ft power cord and an 11.48ft head, this pump can be widely used in swimming pool covers, fish tanks, bathtubs, basements, small ponds, boat barns or roofs, etc.

$GAIZERL-Automatic-Pool-Cover-Pump-fig- $3$$

CARE AND MAINTENANCE PUMP

Always disconnect the pump before cleaning.
Clean the pump when it is visibly soiled or when a drop in performance is detected.
The pump needs to be cleaned periodically.

Steps to cleaning the pump

Turn the back cover in the direction of unlocking, and unscrew the back cover lock D.
Remove the bottom cover of the pump ®, filter sponge ® and rotor access cover *.
Take out the rotor assembly 5.
Clean the filter sponge (replaceable) and rotor.
Please note that the Gasket (a) and Shaft Sleeve (b) on the rotor assembly cannot be lost.

WARNINGS

If the pump fails to operate:

Check to make sure the power cord is plugged in, the pump is getting power and the pump is fully submerged.
Check the pump outlet and hose for blockage.
lean the filter sponge and rotor.
If the performance of the pump is not satisfactory or the pump does not flow evenly:
Check to make sure the pump is completely submerged in water.
Check to make sure the filter sponge, rotor, water sensor and shell are clean.