IKEA PILSKOTT Light LED Floor Lamp Instruction Manual

IKEA PILSKOTT Light LED Floor Lamp Instruction Manual

Getting started
Connect your product to the mains or plug the  power cable into the wall socket.
If you have the TRÅDFRI gateway or DIRIGERA hub
Go to App Store or Google Play and download the IKEA Home smart app. The app will take you through the process of installing your product and other devices.

How to steer your lighting
When the product is connected to the mains, it is possible to turn it ON/OFF with the main switch or the foot switch, but if you want to dim or connect your product to other IKEA Home smart products, you need to buy a separate steering device (e.g. a remote control).
The steering device needs to be paired with your wireless product. If you have more than one (1) wireless product, you can pair each one with the steering device so that the entire combination can be turned ON/OFF or dimmed at the same time.

Pairing a steering device to your product

1. Connect at least one (1) product to the mains before you begin the pairing. Make sure that the  mains power is turned ON.
2. Locate the pairing symbol on the LED driver. Hold the steering device close to the pairing symbol (no more than 5 cm away).
3. Press and hold the pairing button on the steering device for at least 10 seconds. A red LED light will shine steadily on the steering device. The product will begin to dim and flash one time to indicate that it has being paired to the steering device.

How to factory reset your driver
If the product does not respond or if you want to un-pair the product from a steering device, you might have to perform a factory reset. The unit is forced to factory reset by carefully pushing and holding in the small button (marked RESET) with a tip of pen on the LED driver enclosure and applying slight pressure.
A factory reset can also be performed by toggling the main switch 6 times.

IMPORTANT!

• The product is for indoor use only and can be used in temperatures ranging from 5 °C to 45 °C.
• Do not leave the product in direct sunlight or near any heat source, as it may overheat.
• The declared radio range between the unit and the steering device is measured in open air.
• Different building materials and placement of the units can affect the wireless connectivity range.

Care instructions
To clean the unit, wipe with a dry soft cloth. Never use abrasive cleaners or chemical solvents as this can damage the product.

Technical data:
Type: G2015 PILSKOTT
Input: 220-240 VAC, 50/60 Hz, 14.5 W
Max lumen output: 700lm
Power Supply Unit
Type: ICPSHC24-30-IL44-1
Input: 220-240 VAC, 50/60 Hz, 0.23A
Output: 24.0V DC
Max total load : 1.25 A, 30.0 W
Radio range: 10 m in open air.
Operating frequency: 2400-2483.5 MHz
Output power: 12 dBm

DImension, mm: 220x65x26 mm
Weight: 233 gr
Type of light source(s): LED
Efficiency in full-load: 88 %
No-load power consumption (Pno): 0.24 W
Networked standby power
consumption (Pnet): 0.23 W
Standby power consumption (Psb): N/A
Suitable as dimmer for light sources: Yes

Indoor use only
Manufacturer: IKEA of Sweden AB
(commercial registration number: 556074-7551)
Address: Box 702, SE-343 81 Älmhult, SWEDEN

The crossed-out wheeled bin symbol indicates that the item should be disposed of separately from household waste. The item should be handed in for recycling in accordance with local environmental regulations for waste disposal. By separating a marked item from household waste, you will help reduce the volume of waste sent to incinerators or land-fill and minimize any potential negative impact on human health and the environment. For more information, please contact your IKEA store.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>