TOALLIN L7 Wireless Lavalier Microphone User Manual

L7
Wireless Lavalier Microphone
User Manual

Product Introduction

This product is 2.4G wireless collar microphone for providing professional sound recording, plug and play,app-free.
It is widely used for online streaming, video vlog, interviews, online teaching & training,online meeting etc.It is a dual channel microphone system which consists of 2 transmitter and 1 receiver (as below picture shows)

Functions

1. Functions of Transmitter
   1. Windshield Clip Buckle| 8. External Mic in
   ---|---
   2. dB Button| 9. Reset Hole (for pairing)
   3. Power Button| 10. Type-C Charging Port
   4. Wireless Indicator| 11. Built-in Condenser Mic
   5. NR Indicator| 12. Magnetic Pole
   6. Reverb Indicator| 13. 360° Rotatable Clip
   7. Charge Indicator|

Transmitter Operation Instruction

pairing NR stays blue: paired
Mute/Dismute Mic| Single Press| NR slowly flashes blue:Mute NR stayes blue: Dismute
Turn on/off Bluetooth| Double Press| Wireless flashes blue: searching for pairing Wireless stays blue: paired
Wireless light off:bluetooth turned off
dB Button| Turn on/off Noise Reduction| Long Press| Under Recording Mode:
Turn on: NR stays blue, DSP/Reverb stays green: Turn off: NR stays blue, DSP/Reverb light off Under Reverb Mode:
Turn on: NR light off, DSP/Reverb stays white Turn off: NR light off, DSP/Reverb stays blue
| Gain (3-pad cycled)| Single Press| Pad 1:NR lastly flashes blue 1 time Pad 2:NR lastly flashes blue 2 times Pad 3:NR fastly flashes blue 3 times
| Swith between Reverb & Recording| Double Press| Recording Mode: NR stays blue, DSP light off Reberb Mode:NR light off, DSP stays blue
Reset Hole| For repairing between TX & RX| Use a pin to single poke TX first, and then single poke
RX reset hole for Mic 1 & double poke RX reset hole for Mic 2| Poke the reset hole to the ones only unpaired accordingly.
USB-C Port Magnetic Pole| Charging for TX| Connect USB cable to charge Put into charging case to charge| Only Charge stays red. No matter using cable or case to charge, TX will automatically turn off. When fully charged, Charge light off
Charging for TX| /| Charge flashes red for every 2 seconds till power off
Other Ports| 1. 3.5mm AUX:Ear monitoring 2.USB C: Charing & Firmware Updation
2. 3. 4. 5. Functions of Receiver1. State Indicator
2. Charge Indicator
3. Mic 1 Indicator
4. Mic 2 Indicator
5. Ear Monitoring/Audio out to Camera
6. Type-C Audio out
7. Type-C Charing Port (could charging for mobilephone)
8. Magnetic Pole
9. Reset Hole (for pairing)
10. Power on & off
11. 360° Rotatable Clip
Receiver Operation Instruction****

pairing State & Mic 1 & Mic 2 stays blue:TX 1 & TX 2 Paired All lights off: RX turned off
Reset Hole| Repairing with TX| Single poke reset hole for Mic 1
& Double Poke reset hole for Mic 2| Paired: Mic 1 or/and Mic 2 stays blue
Unpaired: Mic 1 or/and Mic 2 flashes blue
Works only lost connection with TX.Need to poke TX first before poke RX.
USB-C Charging| charing for RX| Connect USB cable to charge
Put into charging case to charge| Charge stays red.
No matter using cable or case to charge, RX will still work.
When fully charged, Charge light off
Other Ports| Low Battery Warning| /| Other Ports Charge flashes red for every 2 seconds till power off
1. 3.5mm AUX:Ear monitoring out+ Camera signal out 2.USB-C out: Audio out put to mobile + local charging for RX + RX firmware updation

2. Functions of Charging Case
Charging Case Instruction****

charging and light off when fully charged.
USB-C Port Case| Charging for charging case| Connect USB cable to charge| When charging red light flashes slowly
When fully charged red light stays
Charging Case| When the battery voltage is lower
than 3.4V, enter the low power protection mode| Low Battery Warning| Green light flashes slowly
Green light off,charging case runs out of power.

What’s in the box

Guide of Use

1. Connecting Mobile Phone to Record
   ① Turn on TX and RX to pair, it will automatically be paired for the first use.
   ② Insert mobilephone recording cable to mobilephone
   ③ Open the App like Camera,Tiktok to start recording.

2.  Connecting Mobile Phone to Stream
   ① Turn on TX and RX to pair, it will automatically be paired for the first use.
   ② Insert mobilephone recording cable to mobilephone
   ③ Open the streaming App like Tiktok to start streaming.

3. Connecting Camera to Record
   ① Turn on TX and RX to pair, it will automatically be paired for the first use.
   ② Insert camera recording cable to Camera
   ③ Open the camera to start recording.

Product Specification

Sychronize Charging with
Mobilephone| Support
Sensitivity| -38dB±3dB
Frequency Response| 20Hz~20kHz
Sampling Rate| 48KHz
SNR| ≥75dB
Working Current| ≤25mA
Power-off Current| ≤50uA
Working  Time| 10H（250mA/H battery）
Adapter| 5V/1A
Charging Case| Optional(2200mA/H battery)
Working temperature| -10℃-45℃

Notice

1. Disconnect power and turn off devices before cleaning them.
2. Non-professionals should not disassemble the Devices by themselves to avoid equipment failure and loss of arranty rights.
3. Do not place the device in direct sunlight to avoid premature aging of electronic parts.
4. Avoid using it in places with flying dust or dirty environment. Dust may easily cause equipment failure.
5. Do not place the device in an environment that is too cold or too hot, as it will cause the device to malfunction.
6. It is recommended that the ambient temperature should not exceed -10°C-45°C during use, and the relative humidity should be 10%-95%
7. Do not put anything into the device to avoid short circuit of the device or damage to the circuit. Please do not pour any liquid on the device.
8. Avoid collision between the device and hard objects, so as not to cause surface scratches, detachment or other hardware damage.
9. The product shall not be exposed to such overheated environments as sunshine, fire or similar.
10. The manual contains important information, please keep it

Warranty and Service Information

This product is guaranteed for a period of one year from the date of purchase. Only product defects caused by its quality can be returned for repair or replacement.
The returned product package shall be in its original package or package with an equal degree of protection.
Following information must be presented to obtain Warranty Service:
(a) the product;
(b) proof of purchase clearly indicates date of purchase & product model;
(c) reason for return.
This Warranty does not cover defects or damages that result from:
(a) improper storage, misuse or abuse, accident or neglect, such as physical damage (cracks, scratches, etc.) to the surface of the product resulting from misuse;
(b) contact with liquid, water, rain, extreme humidity or heavy perspiration, sand, dirt or the like, extreme heat, or food;
(c) use of the product or accessories for commercial purposes or subjecting ; the product or accessories to abnormal usage or conditions;
(d) other acts which are not the fault of seller;
(e) damage due to improper operation;
(f) product’s battery which have not been charged over six months.

Customer Service: tai_support@163.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>