CONAIR NPGBT01 Girl Bomb Nose Face and Brow Trimmer Instructions
- June 4, 2024
- ConAir
Table of Contents
Model NPGBT01 FACE FORWARD ™
Nose, Face & Brow Set
Instruction Booklet
For your safety and continued enjoyment of this product, always read the
instruction booklet carefully before using it.
IMPORTANT SAFETY INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE USING FOR HOUSEHOLD USE ONLY
WARNING –
- Use close supervision when the appliance is used by, on, or near children or individuals with certain disabilities.
- Use the appliance only for its intended use as described in this manual. Use only attachments recommended by the manufacturer.
- When cleaning, use cold or warm water. Do not use hot water, seawater or cleaners as they can cause damage to the waterproof seals.
- Do not leave the entire unit submerged in water for a long period of time.
- Do not use the appliance with teeth missing from the blades, as injury may result. Before each use, make certain the blades are aligned properly.
SAVE THESE INSTRUCTIONS FOR TROUBLESHOOTING
There are several things to look for if your trimmer fails to operate:
- Be sure the trimmer is turned on.
- Make sure that the battery is properly placed in the battery compartment. Test the battery to be sure it is working.
- Check the blades to see if they are clogged with hair clippings; if so, use a cleaning brush to remove hair.
- If the trimmer still fails to operate, send it to the Conair Service Center (see Warranty).
OPERATING INSTRUCTIONS
- To insert the battery, twist the battery cover to the left to unlock battery cover. Remove compartment cover by then pulling straight down (Fig. 1).
- Insert 1 AAA alkaline battery, positive terminal downward. (If you are not going to use the device for long periods of time or if the battery is dead, remove the battery from the device. This will increase the battery’s life.)
- After inserting the battery, align the arrow with the “I” on the battery cover then turn clockwise to align with the “O” (Fig. 2).
- Always purchase the correct size and grade of battery most suitable for the intended use.
- Clean the battery contacts and also those of the device prior to battery installation.
- Ensure the batteries are installed correctly with regard to polarity (+ and -).
- Store unused batteries in their original packaging, away from metal objects that could short-circuit them. Never short-circuit batteries.
- This appliance is not a toy. Keep away from children.
INSTRUCTIONS FOR USE
- Twist the battery cover counterclockwise to unlock the battery cover.
- Insert 1 AAA battery according to the polarity marking, return the battery cover, turn to the right and align with “I” and “O” marks to lock, and then twist clockwise again. The unit will start to work when the “I” marks are aligned.
- After use, turn off the power by aligning the “I” mark on the battery cover with the “O” mark (Fig. 1).
GETTING STARTED
TO SWITCH TRIMMER HEADS
- Make sure the unit is turned off.
- Turn the head clockwise until the “▼” mark aligns with the “▲” mark, then lift the head gently (Fig. 3).
- Switch the attachment head and put new head on, then turn counterclockwise and align ▼ with “O” (Fig. 4).
TO TRIM NOSE/EAR HAIR
Use the 3-bevel cutting head for the nose and ears. Gently insert the cutting
head into the nostril or ear and move it slightly back and forth to cut the
hair.
NOTE: To trim nose hair, insert a trimmer no deeper than ¼” at the entry
of nostrils and start trimming the lower hairs until no longer visible.
To trim ear hair, guide the trimmer around the outer surface of the ear.
WET/DRY FEATURE
This device is water-resistant. It may be exposed to splashing water in the
shower and can be rinsed clean under the faucet, but should never be
completely submerged in water.
TAKING CARE OF YOUR
NOSE/EAR TRIMMER BLADE CARE
- Brush away any loose hair that collects in the blades.
- Store the trimmer in a safe location.
- Only use Conair ® blades with this trimmer.
CLEANING YOUR NOSE/EAR TRIMMER
Make sure the trimmer is off.
- To remove the trimmer head for cleaning, turn the head clockwise until the “▼” mark aligns with the “▲” mark, then lift the head gently (Fig. 5).
- Rinse the head only underwater. For the proper functioning of the unit, the handle cannot touch or immersed in water (Fig. 6).
- After cleaning, make sure to shake the head dry before reattaching it to the body.
- To reattach the head onto the body, align the “▼” mark on the head with the “▲” mark on the body and then turn counterclockwise until the “▼” aligns with the “O” mark on the body (Fig. 7).
TO TRIM FACE & BROWS
-
This trimming attachment comes with dual trimming blades. The larger blade is ideal for trimming eyebrows and can also be used to trim unwanted body hair. The smaller blade is ideal for detailing. The double-sided comb attachment helps you achieve an even cut when you do not want to completely remove the hair.
Both sides work well for eyebrow trimming, the long tooth is best for body trimming and the short tooth is best for detailing. -
It also comes with a comb attachment that helps you achieve an even cut when you do not want to completely remove the hair. The comb attachment has two sides: The long tooth is for body hair, and the short tooth is for eyebrow trimming. Aligning the indicator with the L mark on the comb leaves hair longer while aligning with the S mark leaves hair shorter (see Fig. 8).
-
To use the comb attachment, be sure the unit is turned off and slide the comb over the trimming blades (Fig. 9). Make sure that the teeth of the comb are facing in the same direction as the trimming blade, and that the top of the comb is even with the top of the trimmer.
-
If you want to completely remove hair, use the trimmer without the comb attachment.
-
When finished trimming, turn the unit off by turning the battery cover to the left, so “I” mark on the battery cover aligns with the “O” mark, and store the trimmer with the comb attachment over the trimming blades.
TAKING CARE OF YOUR FACE & BROW TRIMMER BLADE CARE
Because the trimmer blades are precision made for a very special use, they
should always be handled with care. Each time you finish using the trimmer,
take the cleaning brush provided and brush away any loose hair that has
collected in the blades, then rinse blades under water only, allow to air-dry
and store the trimmer until the next use.
To promote the long life of the appliance, use your trimmer only for the
purpose intended by the manufacturer.
CLEANING YOUR FACE & BROW TRIMMER
Make sure the trimmer is off.
- Turn the head clockwise until the “▼” mark aligns with the “▲” mark, then lift the head gently (Fig. 5).
- Rinse head under water (Fig. 10).
- After cleaning, make sure to shake the head dry before reattaching it to the body.
- To reattach the head onto the body, align the “▼” mark on the head with the “▲” mark on the body and then turn counterclockwise until the“▼” aligns with the “O” mark on the body (Fig. 7).
BATTERY SAFETY INFORMATION
- This product requires 1 AAA battery.
- Since batteries are sensitive to high temperatures, keep them in a cool, dry place when storing.
- Battery contacts need to be cleaned, both on the battery and in the appliance, before installation.
- The battery should be removed from the appliance when not being used for long periods of time (e.g., months).
- Never recharge non-rechargeable batteries.
- Use only the power cord supplied with the appliance.
- Be careful and install (+) and (-) on the battery to the correct plus and minus on the device.
- Replace all old batteries at one time. Do not mix old and new.
- Remove the discharged battery immediately to avoid leakage.
- Never put batteries into a fire.
- Switch off the device after use.
- Keep batteries away from children, especially the batteries that are small enough to ingest.
- If a battery is ingested, seek immediate medical help.
- Never open, crush, puncture or disassemble the battery.
- Dispose of batteries according to any state and local regulations.
BATTERY DISPOSAL
The AAA battery is not recyclable and does not contain hazardous materials.
The battery can be safely disposed of with normal household waste.
TRIMMER FEATURES
- Removable nose/ear trimming head
- Power handle with LED light
- Eyebrow trimming head
- Eyebrow attachment comb
- Protective cap
LIMITED TWO-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your unit free of charge for 24
months from the date of purchase if the appliance is defective in workmanship
or materials.
To obtain service under this warranty, return the defective product to the
service center listed on the back, together with your purchase receipt.
California residents need only provide proof of purchase and should call
1-800-3-CONAIR for shipping instructions. In the absence of a purchase
receipt, the warranty period shall be 24 months from the
date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED
TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, SHALL BE LIMITED IN DURATION TO THE 24-MONTH DURATION OF THIS
WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on how long an
implied warranty lasts, so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR
IMPLIED, WHATSOEVER. Some states do not allow the exclusion or limitation of
special, incidental, or consequential damages, so the above limitation may not
apply to you.
This warranty gives you specific legal rights, and you may also have other
rights, which vary from state to state.
Please register this product at
www.conair.com/registration
©2022 CONAIR LLC Service Center Conair LLC
Service Department 7475 North Glen Harbor Blvd.
Glendale, AZ 85307 21NP081577IB-17494