AVTEQ NEATFRAME-STAND Neat Frame Floor Stand Installation Guide
- May 15, 2024
- AVTEQ
Table of Contents
AVTEQ NEATFRAME-STAND Neat Frame Floor Stand
PACKAGE CONTENTS
Included with Neat Frame Floor Stand:
- A. Base plate [x1]
- B. Body column [x1]
- C. Front cover [x1]
- D. Rear cover [x1]
- E. 1/4” Washer [x6]
- F. Round 1/4-20 1/2” screw [x6]
- G. Flat 1/4-20 1/2” screw [x1]
- H. Socket M6x1.0 10mm long screw [x2]
- I. Flat 3/8-16 1.25” screw [x3]
Instruction For Use
STEP 1
Secure base to body column
- Place body column (B) on top of the base plate (A) and screw it on from the bottom of the base plate with [x3] flat headed 3/8-16 1.25” screws (I).
STEP 2
Secure front cover to body column
-
Slide the front cover (C) onto the front of the body column (B).
-
Screw [x6] round 1/4-20 1/2” screws (F) with [x6] 1/4” washers (E) into the inner six holes from behind the body column to secure the front cover.
-
(Back view of 6 holes, body column)
-
(Back angled view, body column)
STEP 3
Secure the Neat Frame
- Place the Neat Frame on top of the body column (B).
- Secure the Neat Frame with a [x1] flat 1/4-20 1/2” screw (G). Screw from the bottom into the top inner hole of the body column.
STEP 4
Secure rear cover to body column
- Place the rear cover (D) behind the body column (B).
- Secure the rear cover using a wrench and [x2] socket M6x1.0 10mm screws (H) and screw into the two top holes of the rear cover.
Customer Support
Have a question?
Contact us at support@avteqinc.com
avteqinc.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>