AVTEQ DynamiQ RPS-500 Height Adjustable Mobile Display Instructions
- October 30, 2023
- AVTEQ
Table of Contents
EASY SETUP GUIDE
DynamiQ RPS-500
Items Included
Items needed for install
-Phillips screw driver
-Wrench 3/4”
Install Tip: As you are installing the bolts and nuts, leave them all loose. Install all of them before tightening.
Attach Casters (J) to the end of each Leg (A). Make sure the Casters with
Brakes are installed in the front of the cart.
Attach each of the Horizontal Supports (B) (C) (D) to the
first Leg (A) using the Bolts (G) and Washers (H) as shown. Make sure the flat
side of each support is facing the front of the cart.
Attach the other Leg (A) to the Horizontal Supports (B) (C)
(D) using the Bolts (G) and Washers (H) as shown.
Secure Mount Cover (L) between the Top and Middle Horizontal
Supports using the Phillips Head Bolts (G) and Washers (H) as shown.
Attach the DynamiQ 400 Mount (K) to the frame by aligning
the holes on each side of the mount with the hooks on the top Horizontal
Support. 
7. Please refer to the instructions in the BB VESA mount
for VESA mount assemble and please refer to the instructions in the
DynamiQ/BalanceBox 400 series mount for adjusting the DynamiQ mount. See UM-1
Adaptor and CSB Mount Instructions if using cart with Cisco boards
AVTEQ.net
800-285-8315