WAVEFORM WF-113WE Coax Window Entry Cable Installation Guide
- May 15, 2024
- WAVEFORM
Table of Contents
WAVEFORM WF-113WE Coax Window Entry Cable
What’s In The Box
**A** 1x Coax Window Entry Cable (Quad or Twin)
**B** 4x Screws & Wall Anchors
Compatible Window Types
Here are some of the window types that are compatible with the Coax Window Entry Cable.
-
Sliding*
-
Awning
-
Hung
-
Casement
-
Hopper
Step 1. Connect Window Entry Cable
-
Loosely position entry cable in window frame, with larger case outside.
-
Check that your window fully closes. If not, reach out to us!
-
Connect indoor connectors to your cellular router or extension cables.
-
Connect the outdoor connectors to your antenna or extension cables.
-
Restart your cellular router and perform 1-2 speed tests to test performance.
Important Tips
- If your window has a window-screen, it will need to be removed during the installation process.
- Make sure to use Waveform antennas and extension cables that include weatherproofing boots for the outdoor SMA connectors.
-
- For sliding windows, do not place the cable over the sliding rails.
Step 2. Mount Window Entry Cable
- Clean and dry the surface.
- Remove the adhesive film.
- Firmly press the case onto the surface.
-
Begin with the outdoor case. Twist a flat screwdriver inside each recess to detach top cover.
-
Position onto the surface.
If necessary, drill pilot holes and/or insert wall anchors. For added security, use the adhesive pads. -
Use a phillips screwdriver to install the screws. Reattach the top cover, close the window, and repeat for indoor case.
Step 3. Reposition Connectors (Optional)
Step 3. Reposition Connectors (Optional)
The indoor and/or outdoor cables of your Window Entry Cable can be moved to
follow your cable path and help prevent sharp bends or strain on your cables.
The Window Entry Cable offers three different cable positions for each
connector case:
To reposition, follow these steps:
-
Twist a flat screwdriver inside each recess to detach top cover.
-
Pull out the connector plate and the cover plate you wish to swap.
-
Replace the connector plate and cover plate into their new positions.
-
Reattach the top cover of the case.
CUSTOMER SUPPORT
We get super excited to see photos of our products in action.
Email pictures of your install to
help@waveform.com and brighten our day!
Questions? Suggestions? Need help? Call 1-800-761-3041, or email help@waveform.com
Your Coax Window Entry Cable is designed, sold, and supported by Waveform and
our team of Signal Specialists.
If you have any questions or feedback on how we could make this cable or
manual better, please reach out! We’d love to hear about your experience with
this product!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>