soundmaster KCD50 Kids CD Player User Manual

: June 4, 2024
: soundmaster

soundmaster KCD50 Kids CD Player

Safety, Environmental and Setup Instructions

ENVIRONMENTAL PROTECTION

Do not dispose of this product with the normal household waste at the end of its life cycle. Return it to a collection point for the recycling of electrical and electronic devices. This is indicated by the symbol on the product, user manual or packaging The materials are reusable according to their markings.
By reusing, recycling or other forms of utilization of old devices you make an important contribution to the protection of our environment.
Please contact your local authorities for details about collection points.

This symbol indicates the presence of dangerous voltage inside the enclosure, sufficient enough to cause electric shock.

This symbol indicates the presence of important operating and maintenance instructions for the device

Used batteries are hazardous waste and NOT to be disposed of with the household waste! As a consumer you are legally obligated to return all batteries for environmentally responsible recycling – no matter whether or not the batteries contain harmful substances*) Return batteries free of charge to public collection points in your community or shops selling batteries of the respective kind. Only return fully discharged batteries
*) marked Cd = cadmium, Hg = mercury, Pb = lead

Only use mercury and cadmium-free batteries.
Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!
Keep batteries away from children. Children might swallow batteries.
Contact a physician immediately if a battery was swallowed.
Check your batteries regularly to avoid battery leakage.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
CAUTION: Danger of explosion if battery is incorrectly replaced
Replace only with the same or equivalent type

WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD
This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.

| CAUTION – INVISIBLE LASER RADIATION WHEN OPENING THE COVER OR PRESSING THE SAFETY INTERLOCK. AVOID EXPOSURE TO THE LASER BEAM.
---|---

Use the device in dry indoor environments only.
Protect the device from humidity.
This apparatus is for moderate climates areas use, not suitable for use in tropical climates countries.
No objects filled with liquids, such as vases, shall be placed on the apparatus.
The mains plug or an appliance coupler is used as the disconnect device, the disconnect devices shall remain readily operable.
Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the specifications on the rating plate.
Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
A damaged mains cable or plug must immediately be replaced by an authorized service center.
In case of lightning, immediately disconnect the device from the mains supply.
Children should be supervised by parents when using the device.
Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS
Do not expose the device to direct sunlight or other heat sources.
Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
Do not cover the ventilation openings!
Install the device at a safe and vibration-free location.
Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.
Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer center.
No naked flame sources, such as lighted candles, should be placed on the unit.
When you are necessary to ship the unit store it in its original package. Save the package for this purpose.
In case of malfunction due to electrostatic discharge or fast transient (burst), remove and reconnect the power supply.
If the unit is not using for a long period of time, disconnect it from the power supply by unplugging the power plug. This is to avoid the risk of fire.
The device is equipped with a “Class 1 Laser”. Avoid exposure to the laser beam as this could cause eye injuries.

LOCATIONS OF CONTROLS

POWER ON/OFF BUTTON
POWER INDICATOR
REPEAT (REP)
PROG
SKIP BACK
LED DISPLAY
CD DOOR
SKIP FORWARD
/ +10
STOP
FM RESET
FM SCAN
FUNCTION SELECTOR
VOLUME CONTROL
DC INPUT JACK
AUX IN JACK
MIC JACK
USB PORT (FOR PLAYBACK ONLY)
BATTERY COMPARTMENT
MICROPHONE HOLDER
MICROPHONE

GETTING STARTED

FM TUNER

This unit is using build-in type FM antenna, you may need to adjust the unit position for maxing signal strength.

CONNECTING POWER

The CD player can be using AC or DC to operate. For DC battery, please insert 6x UM 2/C size batteries. (battery not included)
For AC power supply: Before connecting the power, check that the mains voltage on the rating plate which is same as the voltage in your area.
Plug the DC jack into back of the unit plug the AC adaptor (not included) into the wall socket. The unit is now ready for use.

ON/OFF CONTROL

Press the “POWER” button (1) to turn the unit on:
The display will light and the unit will switch on.
Press the “POWER” button (1) again to switch the unit off.

ENERGY SAVING/ ERP2 REGULATION
This device is equipped with an automatic switch off / STANDBY system for energysaving requirements. This is regulated by an EU-standard and is NOT A MALFUNCTION.
If the CD player turn to standby, press the “POWER” button (1) two times to switch the unit on again. This is ERP2 power management.

ADJUSTING THE VOLUME

Adjust the “VOLUME” control (14) to increase or decrease the volume level

SELECTING A SOURCE

You can choose to listen to following sources by using “FUNCTION” switch (13) :

FM
AUX
CD
USB

FM RADIO

Tune to FM radio stations Position the unit as far as possible from TV, power adapter or other radiation source.

Set the “FUNCTION” selector (13) to FM position.
The FM indicator will light on.
Press the “FM SCAN” button (12) to search FM station with strong reception automatically.
Repeat step 2 to tune to more stations.
If need to clear or reset the current station to beginning, press “FMRESET” button (11).

LISTENING TO A CD

This player can playback CD, MP3 and WMA audio format. To select CD operation:

Set the “FUNCTION” selector (13) to CD position

LOADING DISCS

Press the Open/Close marking on CD door to open. Display show “OP”
Gently place a disc on the center spindle with the label up side.
Once in place, press the center of the disc until it clicks into place on the turntable.
Close the CD door.

After a few seconds the disc will read and the disc data. For the tracks display 3 digits:

For the CD-MP3/ CD-WMA disc contains folder: F stand for folder and following 2 digits for folder number

UNLOADING A DISC:

If the disc is playing, press the button (10) and wait a few seconds for the disc to stop.
Press the Open/Close marking on CD door to open.
Grip the disc at the sides and lift it out of the disc compartment.

CD PLAYBACK

Load the CD.
CD playback starts when closed CD door
If not, press the button (9) to start the CD playing
Display show the current track number.
When a CD is playing, pressing the button (9) at any time will pause playback and tracks display blinks.
Press the button again to re-start playback.

Selecting tracks:

Press the or button (5 or 8) briefly to select the previous or next track from the disc.
Press and hold the or button (5 or 8) to search the passage backward or forward.
Press the and hold the / +10 to increase the title number by 10 titles.

CD REPEAT

You can repeat a single track or the whole disc.

In CD mode, press the “REP” button (3) to cycle through the options of repeat current track, the REP indicator blinks.
For Repeat all tracks (whole disc), the “REP” indicator will go stable.

PROGRAM PLAY

For CD disc, you can store a random sequence of up to CD-20 and MP3/WMA- 99 tracks to play in your preferred order.
To store a program track(s):

In CD Stop mode, press the “PROG” button (4).
Display showing [P01] and “PROG” indicator blinks.
P stand for program and following 2 digits stand for program number.
Press the or button (5 or 8) to select the track number for the first track you want to program.
Press the “PROG” button (4) to store this track into the program memory. The track will be store and the program counter will increase to “P02”.
Repeat the above two steps to store the next and subsequent tracks in your program sequence.
When you have finished entering all tracks in your program, press the button (9) to start the program playing.

To clear a program

During program playing, press the button (10) twice.
Open the CD door.

Note: USB program play is same operation.

LISTENING TO AN USB

Set the function selector to USB position.
Press button (99 to playback the music.
The operation procedures are the same as CD playback.

NOTE:
– Compatible storage device (up to 32GB).
– Please do NOT use a USB extension cable to connect your USB flash drive. Such cable can pick up additional interference which can corrupt the data flow.
– Always connect your USB flash drive directly to the USB port without USB extension cable.
– Due to some USB drive manufacturer’s non-compliance with the full USB 1.1/ 2.0 standard. A small percentage (about 5%) of USB flash drive might not be compatible

AUX-IN JACK

Set the “FUNCTION” selector (13) to AUX position
Connect your auxiliary device to the 3.5mm AUX IN socket at the back of the unit.
Turn the “VOLUME” control (14) to set the volume level
Play your auxiliary device.

SINGING ALONG – MICROPHONE JACK

There is a “ MIC” input jack (17) and included microphone that allow you to sing along with sound of the available sources .

Plug the provided microphone into “MIC” jack (17).
Start playback as described on CD PLAYBACK instruction page.
Slide the MIC’s “ON/OFF” switch to the “ON” position and sing along!
Adjust the “VOLUME” control (14) to desired level.
Note: The microphone sound level was 80% of master volume.
To shut off the microphone, slide the “MIC’s ON/OFF” switch to the “OFF” position.
Note: Please always switch the “MIC’s ON/OFF” to “OFF” position when placing to the unit -MIC holder. Otherwise, very high frequency echo noise will be heard.

TECHNICAL SPECIFICATIONS

DC input:	DC 9V, ⎓1000mA
Battery supply	DC 9V ⎓(6 x “C ” SIZE LR14)
Power consumption	14W
Output power :	2 x 1.2W
Frequency range:	87.5-108 MHz (FM)

IMPORTER

Hereby, Wörlein GmbH declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU
A copy of the declaration of conformity can be obtained from the above address.

Wörlein GmbH
Gewerbestrasse 12
D 90556 Cadolzburg
Germany

Tel.: +49 9103 71 67 0
Fax.: +49 9103 71 67 12
Email: service@woerlein.com
Web: www.woerlein.com