soundmaster UR270RO Clock Radio Instruction Manual

June 4, 2024
soundmaster

soundmaster UR270RO Clock Radio Instruction Manual

ENVIRONMENTAL PROTECTION

Do not dispose of this product with the normal household waste at the end of its life cycle. Return it to a collection point for the recycling of electrical and electronic devices. This is indicated by the symbol on the product, user manual or packaging.

The materials are reusable according to their markings. By reusing, recycling or other forms of utilization of old devices you make an important contribution to the protection of our environment.

Please contact your local authorities for details about collection points.

WARNING

Risk of electric shock
Do not open!

Caution: To reduce the risk of electric shock, do not remove the cover (or back). There are no user serviceable parts inside. Refer servicing to qualified service personnel.

**** This symbol indicates the presence of dangerous voltage inside the enclosure, sufficient enough to cause electric shock.

**** This symbol indicates the presence of important operating and maintenance instructions for the device.

Safety, Environmental and Setup Instructions

  • Use the device in dry indoor environments only.

  • Protect the device from humidity.

  • Do not open the device. RISK OF ELECTRIC SHOCK! Refer opening and servicing to qualified personnel.

  • Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with the specifications on the rating plate.

  • Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.

  • A damaged mains cable or plug must immediately be replaced by an authorized service center.

  • In case of lightning, immediately disconnect the device from the mains supply.

  • Children should be supervised by parents when using the device.

  • Clean the device with a dry cloth only.
    Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!

  • Do not expose the device to direct sunlight or other heat sources.

  • Install the device at a location with sufficient ventilation in order to prevent heat accumulation.

  • Do not cover the ventilation openings!

  • Install the device at a safe and vibration-free location.

  • Install the device as far away as possible from computers and microwave units; otherwise radio reception may be disturbed.

  • Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized service/ customer center.

  • Only use mercury and cadmium-free batteries.

  • Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!
    Return the batteries to your dealer or to collection points in your community.

  • Keep batteries away from children. Children might swallow batteries.
    Contact a physician immediately if a battery was swallowed.

  • Check your batteries regularly to avoid battery leakage.

  • Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.

  • CAUTION: Danger of explosion if battery is incorrectly replaced Replace only with the same or equivalent type

Used batteries are hazardous waste and NOT to be disposed of with the household waste! As a consumer you are legally obligated to return all batteries for environmentally responsible recycling – no matter whether or not the batteries contain harmful substances*).

Return batteries free of charge to public collection points in your community or to shops selling batteries of the respective kind

Only return fully discharged batteries.

*) marked Cd = cadmium, Hg = mercury, Pb = lead

FUNCTION AND CONTROLS

FUNCTION AND CONTROLS
FUNCTION AND CONTROLS

  1. ALARM 1 ON -OFF SET/ VOLUME DOWN
  2. ALARM 2 ON -OFF SET/ VOLUME UP
  3. << / TUNE – / YEAR/MONTH/DAY
  4. / TUNE + / DISPLAY LIGHT AUTO ON/OFF

  5. NIGHT LIGHT ON/OFF/AUTO-SENSOR ON-OFF
  6. TO SET THE NIGHT LIGHT INTENSITY LOW-HIGH
  7. AUTO-SENSOR FOR NIGHT LIGHT
  8. TIME SET/MEMORY/MEMORY+
  9. SNOOZE / SLEEP / DIMMER/DST
  10. ON / OFF
  11. RATING LABEL
  12. DISPLAY
  13. NIGHT LIGHT
  14. SPEAKER
  15. BATTERY COMPARTMENT
  16. AC POWER CORD
  17. FM ANTENNA

LED DISPLAY

LED DISPLAY

Power connection
Plug the AC power cord to a household outlet AC source. This unit is equipped with a battery back up system, it requires a 3V CR2032 flat lithium battery (not included). Insert the battery in the battery compartment, making certain that the positive and negative (+ and -) battery terminals are attached to the corresponding terminals on the plate in the battery compartment. If an AC power failure occurs, the clock automatically switches to the battery power supply, the clock and timer memory continue running. When the AC power resumes, the clock switches back to AC again.

Auto-sensor LED night light

Auto-Sensor LED Night Light is a safe way to provide a light for your room, LED Bulb lasts for thousands of hours! Press & hold the night light button (5) for 3 seconds, the LED display Autosensor Indicator will light on. The night light automatically turns on in the dark and turns off in the light.

Getting started

Time and calendar manual setting

  1. Setting Time and Calendar – Press time set button (8) in normal mode and keep depress over 2 seconds to enter time set mode, after enter the setting mode, press time set button (8) to change the mode cycle as follows :
    Normal → Year → Month → Day → 12/24 H ї Real time Hour → Real time Min → Normal
    Action (during data adjustment):

    • Press << / Tune – button (3) to adjust data backward.
    • Press >> / Tune + button (4) to adjust data forward.
    • Keep depress << or >> button for 2 seconds to enable auto forward.
  2. Setting Alarm 1 and Alarm 2 – Press the alarm set button (1/2) during normal mode to show the alarm time. Afterwards keep depress the alarm set button (1/2) over 2 seconds to enter the alarm set mode. After enter the setting mode, press the alarm set button (1/2) to change the mode cycle as follows:

Normal → AL 1 Hour → AL 1 Min → AL 1 weekday Alarm → AL 1 wake beep → AL 1 wake radio → AL 1 wake radio volume → Normal.

Normal → AL 2 Hour → AL 2 Min → AL 2 weekday Alarm → AL 2 wake beep → AL 2 wake radio → AL 2 wake radio volume → Normal.

Select alarm weekday mode as follows

1-5 : Monday to Friday
1-7 : Whole week
6-7 : Saturday & Sunday
1-1 : One day of week

Action (during data adjustment) :

  • Press << / Tune – button (3) to adjust data backward.
  • Press >> / Tune + button (4) to adjust data forward.
  • Keep depress << or >> button for 2 seconds to enable auto forward.

Enable / disable the Alarm

Press and hold the “ALARM 1” (1) / “ALARM 2” (2) button to enable or disable the alarm. Once the alarm is activated, the bell symbol will be appeared on the display.

Alarm duration and snooze function

Alarm Duration – Beep alarm or radio alarm will continue output for 30 minutes if no key press, then it will stop automatically and wait for same alarm time on next day.

Action for Snooze

  • During alarming, press Snooze button (9) will enable snooze function, Beep alarm or Radio alarm will stop.
  • Snooze interval is 9 minute (not include second offset)
  • Snooze will continue unless press ON/OFF button (10) to alarm off of Buzzer alarm or Radio Alarm stop automatically after 30 minutes

Display light auto on/off function

  • Press >>/TUNE+/DISPLAY LIGHT AUTO ON-OFF button (4) for 3 seconds, the LED display Indicator will light on, the LED display will turn off after 15 seconds automatically, Press any button to maintain the LED display for 15 seconds.
  • Press >>/TUNE+/DISPLAY LIGHT AUTO ON-OFF button (4) for 3 seconds, the LED display Indicator will light off to cancel this function.
    Display Instructions

Listening to Radio

Press the ON/OFF button (10) to turn the unit on.
Use the Tune + or Tune – button to select the desired radio station. If you press and hold the Tune + or Tune – button for one second, the release, the unit will automatically scan to the next broadcasting station.
Press the ON/OFF button (10) to turn the radio OFF.

To set / recall the radio presets

Press the ON/OFF button (10) to turn the unit ON.
Use the Tune + or Tune – button to select the desired radio station.
Press and hold the memory / memory+ button; “P01” will blink in the display.
Use the Tune+ or Tune- button to select the desired preset station (P01-P10)
Press the memory / memory+ button again to set the preset.
Repeat steps 2 through 5 to set more presets.
The unit can preset 10 stations totally for FM.
When “P01-P10” is blinking, press the Tune+ or Tune- button to select the preset number.
When recalling preset stations, press memory / memory + button to select the preset number.

Note

  • Ensure that the FM antenna is completely unrolled and extended for best FM reception.

Sleep operation

When listening to radio, press Snooze / Sleep/dimmer/DST button (9) to enter sleep mode. You can just adjust the sleep timer from 90 mins to 15 mins by pressing the Snooze / Sleep/dimmer/DST button (9). The unit will automatically turn off after the selected time.

Select DST (daylight saving time) mode

For countries with daylight saving time (DST).the clock radio offers you DST option to adjust summer time.
In standby mode press and hold SNOOZE/SLEEP/DIMMER/DST button (9) for 3 seconds. The clock advances by one hour. To exit DST mode, repeat the above operation.

Specifications

  • Frequency range : 87.5 – 108 MHz
  • Battery backup : 3V (CR2032 Flat Lithium battery x 1) not included
  • Power supply : AC230V 50Hz

Resetting

If the system does not respond or exhibits erratic or intermittent operation, you may have experienced an electrostatic discharge (ESD) or a power surge that triggered the internal microcontroller to shut down automatically. If this occurs, simply disconnect the ac power cord and remove the system backup battery, wait for at least 3 minutes and then setup the unit again as if it is a brand new unit.

Copyright by Wörlein GmbH, D 90556 Cadolzburg – soundmaster®
Technical specifications, changes and errors are subject without any notice

MANUFACTURER

Hereby, Wörlein GmbH declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU.
A copy of the declaration of conformity can be obtained from the above address.

Wörlein GmbH
Gewerbestraße 12
D 90556 Cadolzburg, Germany

Tel: +49 9103 71 67 0
Fax: +49 9103 71 67 12
E-Mail: info@soundmaster.de
Internet: www.soundmaster.de

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

soundmaster User Manuals

Related Manuals