JinHua LY01 Fourth Generation Box PCB Line Instructions
- May 15, 2024
- JinHua
Table of Contents
JinHua LY01 Fourth Generation Box PCB Line
Assembly and Installation Instructions
- Assembly the battery first,then open the power supply. 2.Install the sensor on the non-rotating structure of the exercise bike, and the nearest magnet shall not be greater than 5MM
- When cycling the stationary bike, the rotating mechanism drives the magnet and sees or to induction, one circle one induction
- Bluetooth SOC chip as a microprocessor, when receiving the induction signal for processing, and sent to the mobile APP for display records and other functions.
FCC Rules
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.