NOVY 40 00x 10536 MA2 LR Hob Hood Instruction Manual

: June 4, 2024
: NOVY

Table of Contents

GENERAL INFORMATION
Safety
INSTALLATION
Documents / Resources

40 00x 10536 MA2 LR Hob Hood
Instruction Manual
40 00x Novy Up NOVY 40 00x 10536 MA2 LR Hob Hood

GENERAL INFORMATION

General
These are the mounting instructions for the Novy hood shown on the cover. The user manual is a separate booklet that is supplied with the hood. Carefully read these instructions before installing and commissioning the hood.
A number of symbols are used in these mounting instructions. The meanings of these symbols are given below.

Symbol	Meaning	Action
Indication	Explanation of an indication on the hood.
****	Warning	This symbol indicates an important tip or a dangerous

situation

Safety

Observe the following mounting and safety tips for mounting:

The installation and electrical connection of the unit shall be carried out by an authorized expert.
The manufacturer does not accept any responsibility for any damage resulting from faulty building or connection.
Check if all mounting materials have been supplied using the drawings on page 4.
The unit is intended for household use only (preparation of food) excluding any other domestic, commercial or industrial use.
Safety can only be guaranteed if the unit is connected to an earth wire in accordance with the required regulations.
Do not use an extension cord for connecting to the electricity grid.
Replace defective or damaged parts only with original Novy parts.

Important before mounting
Page 4 of these mounting instructions shows the mounting drawings. Observe the following mounting tips before starting the mounting activities:

For easier mounting of the hood, it is recommended to do this with at least 2 persons.
The housing of the unit to be mounted has the right dimensions.

NOVY 40 00x 10536 MA2 LR Hob Hood - fig

| | E| F| R| S| T| Z
---|---|---|---|---|---|---|---
40 000| 486| 500| 7| 495| 524| 7
| 40 002| 852| 500| 7| 876| 524| 7
40 004| 852| 500| 7| 876| 524| 7
40 006| 862| 500| 7| 876| 524| 8
40 008| 862| 500| 7| 876| 524| 7
| 40 000 +
40 00 (2-8)| 1354| 500| 7| 1368| 524| 8
| 40 00 (2-8) +
40 00 (2-8)| 1735| 500| 7| 1749| 524| 8

(*) wok or teppanyaki always needs to be installed on the right side.
(**) Reference 40 000 always needs to be installed on the left side

INSTALLATION

Make sure that the power circuit to which the unit is connected is switched off.

Check that all the domino hob(s) accessories are present in the packaging.
Check that all the hood accessories are present in the packaging.
Surface mounting
Make a cut-away in the tabletop in accordance with table 3c.
Flush mounting
Make a cut-away in the tabletop in accordance with table 3c.
Check the dimensions according to the chosen installation method
Remove the protective foil from the top of the decorative cover plate.
Press centrally on the extraction tower air valve so that it moves upwards.
Remove the protective foil around the tower.
Pce the unit in the opening provided. Place it with the frame on the right at about 10 mm from the edge of the recess. Only 40 000
Place it with the frame on the right at about 17 mm from the edge of the recess.
Place the supplied bend on the outlet of the cooker hood.
Place the extractor tower nicely straight into the opening of the unit and push it downwards.
Only 40 006
Remove the decorative cover plate from the unit using the 2 nuts on the underside of this plate.
Attach an extra layer of supplied tape (B) to the underside of the decorative cover plate.
Attach the decorative plate back to the unit with equal clearance around the tower.
Slightly loosen the 4 bolts on the side of the unit and tighten the adjusting screw until the tower is flush with the decorative plate. Refit the 4 bolts.
Options Adjust the decorative cover plate if it is not nicely aligned around the extraction tower. Loosen the nuts on the underside of the holders of the decorative plate and adjust. Then tighten the nuts again.
Attach the supplied tape (A) to the 3 marked sides of the domino cooktop WITH additional control (3785 or 3775). * 40 006 only
Attach the supplied tape (B) to the 3 marked sides of the domino cooktop WITH additional control (3775).
Place the domino hob (3785 or 3775) in the housing frame. Connect the connecting cable and control cable in the provided recesses of the frame.
Connect the connector through the cooker hood.
40 002, 40 004, 40 006, 40 008 only Glue the profile on the side of the extraction unit completely to the top X = 0 mm
40 002, 40 004, 40 008 only Attach the supplied tape (B) to the 3 marked sides of the domino cooktop WITHOUT additional control.

40 006 only Attach the supplied tape (A) to the 3 marked sides of the teppan-yaki domino. 17. Place the domino cooktop to the right of the cooktop hood. required, seal the gap between the domino cooktop and the decorative plate around the extraction tower. 18. If rRecir collation built-in box option: connect the in-built box to the hood outlet, if necessary, use optional fittings. 19. Outlet with wall outlet grille option : use optional fittings to make the connection with the duct work possible 20. The installation and connection to the electrical system may only be entrusted to a specialist (electrician) who is familiar with the prescribed standards.
Electrical connection Domino hob ct the wires Brown (BN), Blue (BU), and Green-yellow (GN/YE) to a fused junction box.
electrical connection extractor hood Connect the plug to an electrical outlet.
1. If necessary, align the tower with the 4 adjusting screws in the lift system.

NOVY nv Noordlaan 6
B – 8520 KUURNE
Tel. 056/36.51.00
Fax 056/35.32.51
E-mail: novy@novy.be
http://www.novy.be
France: Tél: 0320.940662
Deutschland und Österreich: Tel: +49 (0)511.54.20.771
Nederland: Tel.: +31 (0)88-0119110
United Kingdom: +44 (0)207 866 2493
España: Tel.: +34 938 700 895
Italia: Tel.: +39 039.20.57.501