MIC BOOSTER CT 1 Dynamic Microphone Booster with High Quality Preamp User Guide
- May 15, 2024
- MIC BOOSTER
Table of Contents
MIC BOOSTER CT 1 Dynamic Microphone Booster with High-Quality Preamp
Safety Instruction
- Please read and follow all instructions.
- Keep the apparatus away from water, except for outdoor products.
- Clean only with a dry cloth.
- Do not block any ventilation openings. Install by the manufacturer’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
- Use only attachments/accessories specified by the manufacturer.
- Use only specified carts, stands, tripods, brackets, or tables.
- Use caution to prevent tip-overs when moving the cart/apparatus combination.
- Avoid installing in confined spaces like bookcases.
- Do not place naked flame sources, such as lighted candles
- Operating temperature range 5° to 45°C (41° to 113°F).
Thank you for purchasing a Klark Teknik Mic Booster! These compact units add a
significant gain boost to your passive microphone signal to ensure strong,
clear delivery to a mixing board, preamplifier or interface
note – the CT 1 can also be connected directly to most microphones
Setup Procedure
Warning – either mutes the mixer channel, lower the volume all the way, or turn off the speaker system before making connections.
- Connect a fairly short balanced XLR cable (<30 feet) from the microphone to the input of your Mic Booster. Note that phantom power be passed to condenser mics, and therefore they shouldn’t be used along with a mic booster unit.
- Connect the output of the Mic Booster to a mixer, preamp, or interface via a balanced XLR cable.
- Long cable runs can be used for this connection if necessary, but high-quality XLR cables with low capacitance are recommended to avoid high-frequency degradation.
- Engage phantom power on the mixer or other receiving equipment.
- Check the gain setting on the receiving channel of your mixer or interface since the signal will be much greater than typical mic levels
Specifications
LEGAL DISCLAIMER
Music Tribe accepts no liability for any loss that may be suffered by any
person who relies either wholly or in part upon any description, photograph,
or statement contained herein. Technical specifications, appearances and other
information are subject to change without notice. All trademarks are the
property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake,
Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Aston
Microphones and Coolaudio are trademarks or registered trademarks of Music
Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2024 All rights
reserved.
LIMITED WARRANTY
For the applicable warranty terms and conditions and additional information
regarding Music Tribe’s Limited Warranty, please see complete details online
at
community.musictribe.com/support.
Hereby, Music Tribe declares that this product complies with Directive
2014/30/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive
2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Gammel Strand 44, DK-1202 København K, Denmark
UK Representative: Music Tribe Brands UK Ltd.
Address: 8th Floor, 20 Farringdon Street London EC4A 4AB, United Kingdom
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>