TAC 40-02290T Side Steps Running Boards Instruction Manual
- March 4, 2024
- TAC
Table of Contents
TAC 40-02290T Side Steps Running Boards
Important Information
INSTALLATION INSTRUCTIONS
PNC SIDE STEP
2019-2023 SILVERADO/SIERRA 1500 CREW CAB 2020-2024 SILVERADO /SIERRA 2500/3500
CREW CAB (Incl. Diesel models with DEF tanks) (Rocker Panel Mount) PART#
40-02290T
PNC SIDEBAR
2019-2023 1500 SILVERADO/SIERRA CREW CAB
2020-2024 2500/3500 SILVERADO/SIERRA CREW CAB (INCLUDES DIESEL W/DEF)
PARTS LIST
| 1 | Driver/left Sidebar | 16 | 8-1.25mm x 30mm Hex Bolts |
|---|---|---|---|
| 1 | Passenger/right Sidebar | 16 | 8-1.25mm x 25mm Combo Bolts |
| 8 | Mounting Brackets | 16 | 8mm Lock Washers |
| 16 | 8mm x 24mm x 2mm Flat Washers |
PROCEDURE
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS RECOMMENDED.
-
Start the installation under the driver side of the vehicle. Locate the 6 plugs along the bottom edge of the body. Mounting Brackets will bolt to the 1st, 3rd, 4th and 6th threaded mounting holes, ( Figures 1— 6 ). Remove the plastic plugs from each mounting location. Directly above each threaded insert is a top mounting location on the side of the body panel. Hold a Bracket up in place to help determine the correct mounting holes to use along the body.
NOTE : Thread an 8mm Hex Bolt into the threaded inserts to clear paint as required. -
Select (1) Mounting Bracket. Starting at the front of the driver/left side, bolt the Mounting Bracket to the factory threaded holes with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, ( Figure 7 ). Do not tighten hardware at this time.
-
Repeat Steps 1 & 2 to install (3) Mounting Brackets on the remaining driver/left side mounting locations along the body panel.
-
Select the Driver/left Sidebar. Use the illustration above to help determine the correct Sidebar. NOTE:
The front stepping pad is farther away from the front end of the Sidebar. Place the Sidebar on top of the Brackets. IMPORTANT : Do not slide, (front to back), the Sidebar on the Brackets or damage to the finish may result. -
Attach the Sidebar to the Brackets with (8) 8mm Combo Bolts, ( Figure 8 ).
-
Level and adjust the Sidebar and fully tighten all hardware.
-
Repeat Steps 1—6 to install the Passenger/right Sidebar.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing
is recommended to add a protective layer over the finish. Do not use any type
of polish or wax that may contain abrasives that could damage the finish.
Aluminum polish may be used to polish small scratches and scuffs on the
finish. Mild soap may be used also to clean the Sidebars.
Driver/left side Installation Pictured
(Fig 1) Driver/left side Rocker Panel mounting locations illustrated (arrows) NOTE : Hold Bracket up to body panel to help determine the correct mounting locations.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>