VITABARRE 4 FT Fixed Height Floor Mounted Ballet Barre System Instruction Manual

Table of Contents

Specifications
- Model: XYZ123
- Colour: Black
- Material: Plastic
- Dimensions: 10 x 5 x 3 inches
- Weight: 1 pound

Follow these steps to effectively use the product:

Step 1: Unboxing
- When you receive the product, carefully unbox it and remove all packaging materials.
Step 2: Assembly
- Assemble the different components according to the provided assembly instructions.
Step 3: Power On
- Connect the product to a power source using the included power cable and switch it on.
Step 4: Setting Adjustments
- Make any necessary setting adjustments using the control panel or remote control.
Step 5: Product Usage
- You can now start using the product for its intended purpose. Enjoy!
Frequently Asked Questions (FAQ)
- Q: How do I clean the product?
- A: To clean the product, use a soft, damp cloth to wipe the surfaces. Avoid using harsh chemicals.
- Q: What should I do if the product malfunctions?
- A: If you encounter any issues or malfunctions, refer to the troubleshooting section in the user manual or contact customer support for assistance.
- Q: Can I use the product outdoors?
- A: This product is designed for indoor use only. Using it outdoors may damage the product and void the warranty.

Once you have determined where the floor stanchions will be located, it is best to use a chalk line or straight edge to ensure a straight line to guide you.
Slide the barre material into the barre collars on the face side of each floor stanchion. Do not install collar screws yet.
The floor stanchions should be spaced no more than 12″ in from each end of the barre with the balance of the stanchions evenly spaced not to exceed 5 feet.
Make sure that a stanchion is located at every barre joint as this will be used to couple the barres together.
Anchor the floor stanchions to the floor using the proper anchor bolts of at least 5/16″ diameter (four anchors per stanchion).
All floor stanchions must be mounted in a straight line.
Note: Anchors for mounting the stanchions to the floor are not included as we have no information on the type of floor they will mount to. Your installing contractor should know which type of anchors to use.
Depending on the level of the floor, it may be necessary to “shim” the floor stanchions by placing flat washers between the floor and the stanchion base plate before final anchoring.
Once the floor stanchions are securely anchored to the floor, position the barre material so barre joints are butted up in the centre of each collar. Install the supplied collar screws (two screws per collar)
Lastly, push the supplied black end caps to the exposed barre ends.

As with any fitness or exercise equipment, use of this equipment should only be used by persons who are physically able to use the equipment as it is designed for.
Proper safety gear such as padded mats, shoes, clothing and the like should always be used.
This equipment should not be used alone. Always have someone nearby in case of an emergency.
Vita, Inc. and its affiliates will not be liable for any injury or death resulting from the use of this equipment.
The user assumes responsibility for the proper assembly, maintenance and use of this equipment.

Read User Manual Online (PDF format)