CYC-BRK Magnetic Brake Sensors Instruction Manual
- May 15, 2024
- CYC
Table of Contents
Magnetic Brake
Sensors
Installation
MAGNETIC BRAKE SENSORS
How To Install Your Magnetic Brake Sensors
Requirements 1 to 4 wiring harness full / half-twist / brake throtle Pair
of magnetic with sensors thumb
Please note that these images are for reference only. Installation should be
done on the bike.
Step 1 – Connect the harness to the brake sensors
There are arrows for connection alignment on both the wiring harness and brake
sensors 
Step 2 –
Place the magnet sticker on your brake handle & place the magnet on the
sticker
The brake sensors & magnets should be placed right next to each other with the
magnet on the inner edge of the brake lever. Step 3 – Take off red tape at the botom of the
sensor & stick the sensor right next to the magnet
When the kit is fully connected & switched on, the brake sensor will show a red light. As soon as the sensor is right next to the magnet, the light will turn blue.
Step 4 –
Repeat these steps for the sensor on the other brake lever & test it
Please
contact
technical_support@cycmotor.com if
further assistance is needed.
CYC Motor Ltd
Hong Kong
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>