V-TAC V5-7 Pressure Washer User Manual
- May 15, 2024
- V TAC
Table of Contents
V-TAC V5-7 Pressure Washer
V-TUF {EQUIPMENT BRAND OF FENCO GROUP LTD.)
WARRANTS TO THE CONSUMER THAT THIS PRODUCT WILL BE FREE OF MATERIAL OR
ASSEMBLY DEFECTS FOR 1 YEAR.
- Please Note: This excludes wearing parts such as hoses, turbo nozzle, pump seals valves etc that wear out and need replacing within the normal working life of the machine.
- Warranty claims must be processed through the dealer from whom the machine was purchased. If you have any problems, please contact V-TUF with your proof of purchase to hand.
- The warranty claim will need to be validated by the manufacturer’s inspection.
Please note that the machine is for light-duty use and is only built to last 96 hours minimum in conformance with CE standards. If the machine has been used in a heavy use application the warranty will not apply. The V-TUF warranty is a manufacturing cover for your domestic product. This warranty shall not apply to defects caused by:
- Misuse
- Neglect
- Accidental Damage
- Improper storage
- Installation or careless handling
- Frost damage/heat damage
- Alteration not carried out or authorised by V-TUF approved supplier
- The use of incorrect supply voltage
- Contaminated water supply
- Unsuitable chemicals
FEN CO GROUP
Limited shall not be liable in any event at any time for any indirect or
consequential loss or damage. The rights and benefits under warranty are
additional to your statutory rights which are not affected by this Warranty.
Item Description
- High-pressure washer
- On/off switch
- Mobile adapter bracket with wheel
- Water outlet (reverse of machine)
- Water inlet
- Gun
- Inlet Filter
- Turbo Quick Nozzle
- Foam Cannon
APPLICATION
The V5 Portable High-Pressure Washer is a multi-functional machine built to the exceptional standards of the VTUF brand. Suitable for use in cars, bikes and other outdoor equipment or garden patios, greenhouses, and brickwork, the V-TUF V5 is an ideal at-home pressure washer.
Helpful Hints for Getting Started
Automatic ON/OFF
The motor is not continuous and will only run when the trigger of the spray
gun is squeezed. After following the start-up procedures in this manual, turn
the pressure washer ON and squeeze the trigger for activation. See
“Operating Instruction” section in this manual for further details.
Bleeding the Gun
It is very important to bleed the gun before using the pressure washer.
Squeeze the trigger to allow any air that is trapped inside of the unit and
hose to escape. Continue to squeeze the trigger until a steady stream of water
comes from the nozzle. (This process may take up to 2 minutes). See the
“Operating Instructions” section for this process.
Safety Regulations
WARNING: Read all the instructions before using the machine.
WARNING: The V5 pressure washer is not to be used by children. Children
should be supervised to ensure that they do not play with the machine. This
machine is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge.
WARNING: When repairing the pressure washer the electrical supply
connection shall be made by a qualified electrician and comply with IEC
60364-1. The electric supply to this machine should include either a residual
current device that will interrupt the supply if the leakage current to earth
exceeds 30 mA for 30 ms or a device that will prove the earth circuit.
WARNING: The machine is intended to be used at temperatures above O
degrees Celsius.
WARNING : The operating method to be followed in the event of an accident
(e.g. contact with detergents: rinse with an abundance of clean water) or
breakdown to prevent unsafe situations.
WARNING: This machine has been designed for use with the cleaning agent
as supplied by V-TUF / FGL and we cannot guarantee that the use of other
cleaning agents or chemicals may not adversely affect the condition of the
machine.
WARNING: We recommend the operator wear suitable PPE for eyes and ears.
WARNING: Do not use the machine within range of persons unless they are
wearing suitable protective clothing.
WARNING: Do not direct the jet against yourself or others to clean
clothes or footwear.
WARNING: Risk of explosion -Do not spray flammable liquids.
WARNING: High-pressure hoses, fittings and couplings are important for
the safety of the machine. Use only hosed, fittings and couplings recommended
by V-TUF.
WARNING: To ensure machine safety we suggest only using original V-TUF
spare parts from the manufacturer or those suggested or approved by V-TUF.
WARNING: The machine shall be disconnected from its power source by
removing the plug from the socket outlet during cleaning or maintenance of the
machine.
WARNING: Observe a distance of at least 30cm when using the jet to clean
painted surfaces to avoid damaging paintwork.
WARNING: Do not use the machine if a supply cord or important parts of
the machine are damaged, e.g. safety devices, high-pressure hoses, or trigger
guns.
WARNING: If an extension cord is used, the plug and socket must be of
watertight construction.
WARNING: Inadequate extension cords can be dangerous. If an extension
cord is used, it shall be suitable for outdoor use, and the connection has to
be kept dry and off the ground. It is recommended that this is accomplished
using a cord reel which keeps the socket at least 60mm above the ground.
WARNING: To avoid a hazard due to inadvertent resetting of the thermal
cut-out, this appliance must not be supplied through an external switching
device, such as a timer, or connected to a circuit that is regularly switched
on and off.
WARNING: The machine is not intended to be connected to portable water
mains.
WARNING: Be aware of the danger of the kickback force on the spray
assembly when opening the trigger gun and grasp the gun with your hands
firmly.
WARNING: To reduce the risk of injury, close supervision is necessary
when a machine is used near children. High-pressure cleaners shall not be used
by children or untrained persons.
WARNING: Do not operate the machine when fatigued or under the influence
of alcohol or medicines that affect reactionary responses.
WARNING: Follow the maintenance instructions specified in the manual.
WARNING: This machine must be grounded. The plug must be plugged into an
appropriate outlet that is properly installed and grounded by all local codes
and ordinances. The rating voltage (V/Hz) of the machine has to comply with
the local power supply voltage.
WARNING: Check with a qualified electrician or service personnel if you
are in doubt as to whether the outlet is properly grounded. Do not modify the
plug provided by the machine. If it will not qualify the outlet, have a proper
outlet installed by a qualified electrician. Do not use any type of adapter
with this machine.
WARNING: To reduce the risk of electrocution, don’t start and run the
machine in the rain or storm. Keep all connections dry and off the ground. Do
not touch the plug with wet hands
WARNING: When the machine is turned on, the interior pumps start and
continue to run even if the pressure wand trigger has not been depressed.
Running the machine for more than 3 minutes without depressing the pressure
wand trigger could cause heat damage to the motor and pumps, please do not
leave the machine running unattended or unused for more than 3 minutes.
WARNING: When the machine is running, please maintain a constant water
supply. Without water, circulation will damage the sealing rings of the
machine.
WARNING: It is necessary to turn on the spray lance within one or two
minutes after the machine has been started. Otherwise, the temperature of the
circulating water within the machine will cause damage to the sealing rings
inside the machine.
WARNING: This machine has been designed for only using cleaning water, do
not use corrosive chemicals.
WARNING: High-pressure jets can be dangerous if subject to misuse. The
jet must not be directed at persons, animals, live electrical equipment or the
machine itself. Pressure washers should not be pointed at tyre walls, as it
may be possible to damage them. WARNING: Do not use the machine if a
supply cord or important parts are damaged, e.g. safety devices, high-pressure
hoses, or trigger guns.
OPERATING INSTRUCTIONS
- This unit is to be connected to a cold-water source ONLY.
- The motor of this pressure washer will NOT run continuously. It will only operate when the trigger is squeezed.
- Connect the outlet hose to the washer and connect the spray gun to the outlet hose.
- Connect nozzle and nozzle extension.
- Check gauze filter is clear of any blockage.
- Connect the water supply hose.
- Check that the hose has no kinks in it.
- Turn on the water and check for leaks.
- Depress trigger to allow air to be expelled through the pump and hoses, lock trigger.
- Plug in the machine and turn on the switch.
- Unlock the trigger and use the pressure washer.
SHUTDOWN
- Turn off the motor (push the switch to the off position)
- Unplug the unit from the power source.
- Turn off the water supply.
- Press the trigger of the gun to depressurize the system.
- Disconnect the garden hose from the pressure washer.
- Wipe all surfaces of the unit with a damp clean cloth.
- Engage the gun safety lock.
CAUTION
ALWAYS turn off the unit’s motor BEFORE turning off the unit’s water supply.
Serious damage could occur to the motor if the unit is run without water.
CAUTION
NEVER disconnect the high-pressure discharge hose from the machine while the
system is still pressurized. To depressurize the unit, turn off the motor,
turn off the water supply and squeeze the trigger 2-3 times.
SPRAY NOZZLES
The Pressure Washer comes with four spray nozzle attachments as standard. Each
nozzle is colour-coded and delivers a specific spray pattern and pressure for
a particular cleaning job. The size of the nozzle determines the size of the
fan spray and the pressure out of the nozzle. 0°Nozzle – Red: This nozzle
delivers a pinpoint stream of pressurized water and is extremely powerful. It
covers only a small area of cleaning. This nozzle should only be directed at
surfaces that can withstand high pressure such as metal or concrete. Do not
use this nozzle to clean wood. (fig 1)
15° Nozzle – Yellow: This delivers a 15-degree spray pattern for intense cleaning. This one is mainly used for cleaning cars and muddy objects. This nozzle should only be used on areas that can withstand pressure from this nozzle. (fig 2) 25° Nozzle – Green: This nozzle delivers a 25-degree spray pattern for intense cleaning of larger areas. This nozzle should only be used on areas that can withstand pressure from this nozzle. (fig 3) 40° Nozzle – White: This nozzle delivers a 40-degree spray pattern and a less powerful stream of water. This nozzle can cover a wide area and should be used for most general cleaning jobs. (fig 4) Chemical Nozzle – Black: This nozzle is used to apply special chemicals and cleaning solutions. This nozzle produces the weakest pressure stream of the five nozzles. (fig 5) The nozzles are stored in receptacles on a panel mounted to the handle of the washer. Colours on the panel identify the nozzle location and spray panel.
WATER INLET SCREEN
The water inlet filter must be inspected regularly, to avoid blockage and
restriction in the water supply to the pump (fig 6).
USING DETERGENT
Add detergent to the container. Set the Adjustable Spray Wand at a low-
pressure position. (fig 7). Trigger gun to spray detergent.
ATTACHING SOAP DISPENSER BOTTLE
Insert the metal end of the spray lance into the opening of the spray gun (making sure to match the locking tabs on either side of the spray lance to the notches of the spray gun), Push in and twist in a clockwise motion to lock the spray lance and spray gun together (make sure there is a tight and secure fitting between both). Insert the end of the soap dispenser bottle with the plastic locking tabs into the opening of the spray lance. Push in, turn, and lock so the soap dispenser bottle and spray lance are firmly secure.
LONG TERM STORAGE
The machine should be stored in a frost-free environment. After long-term
storage without operation, it is possible to form scales inside the machine
making it hard to start again. In such conditions, it is recommended to turn
off and disconnect the power supply and rotate the motor by hand several times
to avoid excessive current draw on the motor and the power supply.
GUN SAFETY DEVICE
Whenever you use the VS high-pressure washer, we suggest you grip in the right
position, with one hand on the handle and the other on the lance, When you
stop the machine it is necessary to use the safety lock placed on the gun to
avoid accidental damage.
CLEANING PIN INSTRUCTION
Using the included tip cleaner insert wire into the nozzle hole and move back and forth until the debris is dislodged.
Remove additional debris by back-flushing water through the nozzle. To do this, place the end of a garden hose (with water running) to the end of the nozzle for 30-60 seconds.
MAJOR TECHNICAL DATA
ITEM
ELECTRICAL DIAGRAM
INSTALLATION, ELECTRICAL AND WATER CONNECTIONS
- PRESSURE CLEANER
- WATER SUPPLY HOSE (not included)
- WATER CONNECTION
- WATER INLET
- HIGH-PRESSURE TUBE
- HIGH-PRESSURE, WATER OUTLET
- SPRAY GUN
- POWER SUPPLY
NOTE
V-TUF continues to develop pressure washers and reserves the right to amend
machine specifications without notice.
INSPECTION & MAINTENANCE
For safe use, we suggest having the machine serviced and cleaned every three
months. Before use make sure to inspect the filter and the nozzle to ensure
there is no damage. After working, make sure there is no water remaining in
the pump and the hose by following previous operating instructions. If the
machine requires repair in the guarantee period then please speak with the
retailer regarding service options and ensure you provide the registered
warranty details For transportation safety. The machine should comply with
ISTA.
Meaning of crossed-out wheeled dustbin
Do not dispose of electrical machines as unsorted municipal waste, use
separate collection facilities. Contact your local government for information
regarding the collection systems available. When replacing old machines with
new ones, the retailer is legally obligated to take back your old machine for
disposal at least free of charge.
TROUBLESHOOTING GUIDE
CE DECLARATION OF CONFORMITY
The undersigned: Mr Eugene Buchner as authorised by: Fenco Group Ltd declares
that this declaration has been issued under the sole responsibility of the
manufacturer. The object of the declaration conforms with the relevant Union
harmonization Legislation. Identification code: V5 – High-Pressure Washer
Description: 21 DOW Pressure Washer Conforms to the following directives and
standards:
- Machinery Directive 2006/42/EC
- EMC Directive 2014/30/EU
- Ro HS Directive 2011 /65/EU Annex II and its amendment Directive (EU) 2015/863
- Outdoor Noise Directive 2000/14/EC(amended 2005/88/EC)
- EN 60335-1:2012+A 11:2014+A 13:2017
- EN 60335-2-79:2012
- EN 62233:2008
- EN 55014-1: 2017
- EN 55014-2:2015
- EN 61000-3-2:2014
- EN 61000-3-3:2013
Applied Conformity Evaluation Method
2000/14/EC: Annex Ill
Sound Power Level dB (A)
Measured: 92
Guaranteed: 96
Notified body: SGSThe technical documentation is kept by: Fenco Group Ltd
Date: 20/08/2019
Signed
Mr Eugene Buchner
Managing Director
Name and address of the manufacturer:
Fenco Group Ltd, Unit 5 Chris Sharp Building
Till Bridge Lane, Scampton, LINCOLN LNl 2SX
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>