TAC 40-51700T Side Steps Running Boards Instruction Manual
- May 15, 2024
- TAC
Table of Contents
TAC 40-51700T Side Steps Running Boards Instruction Manual
INSTALLATION INSTRUCTIONS
PARTS LIST:
| 1 | Driver/Left Sidebar | 1 | Driver/Left Rear Mounting Bracket |
|---|---|---|---|
| 1 | Passenger/Right Sidebar | 1 | Passenger/Right Rear Mounting Bracket |
| 1 | Driver/Left Front Mounting Bracket | 12 | 8mm x 25mm Hex Bolts |
| 1 | Passenger/Right Front Mounting Bracket | 12 | 8mm x 24mm x 2mm Flat Washers |
| 1 | Driver/Left Center Mounting Bracket | 12 | 8mm Lock Washers |
| 1 | Passenger/Right Center Mounting Bracket | 12 | 8mm Combo Hex Bolts w-washers |
PROCEDURE:
-
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
-
Starting on the driver/left front of the vehicle, locate the two factory 8mm threaded holes located in the bottom of the floor panel, (Figure 1).
(Fig 1) Driver/left front and center mounting locations
NOTE: Brackets install in the factory running board mounting locations. Threaded holes may be covered with insulation. Clean mounting locations as required for proper Bracket installation. -
Select the driver/left Front Bracket, (Figure 2).
Attach the Bracket to the threaded holes with (2) 8mm x 25mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers, (Figures 2 & 7). Snug but do not tighten hardware at this time. -
Move to the center of the vehicle. Locate the two threaded holes in the bottom of the floor panel and body support, (Figure 1).
Repeat Steps 2 & 3 to attach driver/left Center Bracket, (Figures 3 & 7).
-
Next, move to the rear of the vehicle. Locate the holes in the bottom and inner side of the floor panel, (Figure 4).
Repeat Steps 2 & 3 to install the driver/left Rear Bracket, (Figures 5 & 7).
-
Carefully position the driver/left Side Step onto the Brackets.
IMPORTANT: Do not slide, (front to
back or rotate), the Side Steps on the Brackets or damage to the finish may result. Attach the Side Step to the Brackets with the included (6) 8mm x 25mm Combination Hex Bolts, (Figures 6 & 7).
Do not tighten hardware at this time. -
Align the Side Step properly and tighten all hardware.
-
Repeat Steps 2—7 for the passenger/right Side Step installation.
-
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing
is recommended to add a protective layer over the finish. Do not use any type
of polish or wax that may contain abrasives that could damage the finish.
For stainless steel: Aluminum polish may be used to polish small
scratches and scuffs on the finish. Mild soap may be used also to clean the
Side Steps.
For gloss black finishes: Mild soap may be used to clean Side Steps.
Driver/left Side Installation Pictured
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>