CREMA B0C5Z51KV1 Barista Pro Barista Touch Instruction Manual

CREMA B0C5Z51KV1 Barista Pro Barista Touch

Specifications

FAQ

• Do I need to unplug the machine before installing the wheel set?
• Yes, it is important to disconnect the machine from its power source and allow it to cool completely before starting the installation process.
• What should I do to protect the machine and catch any residual water during installation?
• Lay a towel on your workstation before tipping the machine to protect it and catch any residual water.
• Can I access the bottom of the machine without laying it on its side?
• Yes, you can carefully hang one side of the machine over the edge of a countertop and work from the floor, doing one side of the machine at a time.
• How should I handle the screws removed during the installation?
• Take note of the screw lengths as they need to be replaced into the same hole from which they were removed. Be careful not to over tighten the screws.
• What is the final step after installing the wheelset?
• Replace the drip tray, accessory tray, and water tank, and your machine is ready to use with its new mobility.

IMPORTANT
Disconnect your machine from its power source and allow the machine to cool completely before moving forward with your installation.

Using Instructions

STEP 1

• Remove the drip tray, accessory tray and water tank from your machine.

STEP2

• Gently rest your machine on its side, providing access to the bottom of the machine.
• To protect the machine, and to catch residual water from the water tank’s inlet, lay a towel on your workstation before tipping the machine.

TIP: Instead of laying the machine on its side, you can also access the bottom of the machine by (carefully) hanging one side of the machine over the edge of a countertop and working from the floor, one side of the machine at a time.

STEP 3
Using a Philips screwdriver, remove the existing rubber feet from the front corners of the machine.
Note that the two screws will be different lengths and in the next step, should be replaced into the same hole from which they were removed.

STEP4

• Separate the rubber insert from the foot’s base by pulling the two pieces apart.
• Match the foot’s base to the correct side of the machine by aligning the notched holes.
• Attach the base with the screws from
• STEP 3, ensuring proper placement of the short/ long screw.

CAUTION: Do not over-tighten screws.
Align the plugs on the rubber foot with the holes in the base and press firmly.
Repeat for the second foot assembly.

STEP 5

• Remove the rear factory feet by removing the two screws holding them in place, taking note of the screw sizes and the holes from which they were removed.
• Match the correct wheel assembly to each corner by orienting the wheel in the direction shown.
• Attach the assembly with the previously removed screws.

CAUTION: Do not over-tighten screws.

STEP6
Replace your drip tray, accessory tray, water tank and. ..
… Get Rollin!’

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>