SEALEY LED3601R.V3 Rechargeable 360 Degree Inspection Light Instruction Manual

: May 15, 2024
: SEALEY

Table of Contents

SEALEY LED3601R.V3 Rechargeable 360 Degree Inspection Light
Product Usage Instructions
INTRODUCTION
OPERATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

SEALEY LED3601R.V3 Rechargeable 360 Degree Inspection Light

SEALEY-LED3601R.V3-Rechargeable-360-Degree-Inspection-Light-
PRODUCT

Specifications

Model No: LED3601R.V3, LED3601G.V3, LED3601CF.V3, LED3601.V3
Battery: 3.7V 1.5Ah Li-Poly
LED Type: 3W COB + 1W SMD
Lumen Output Side/Top: 300/100lm
CRI Rating (Side): 80
Operating Time Side/Top: 3/6hr
Charging Time: 3hr
IP Rating: IP20
Maximum Length: 170mm
Minimum Length: 160mm

Product Usage Instructions

Safety Precautions

Inspect the cable and connector for wear and damage before connecting to the power supply.
Ensure the lamp is fully charged before initial use.
Avoid charging in damp conditions.
Do not turn on the lamp while it is being charged.
Avoid shining the light directly into your eyes.
Keep the lamp away from children.
Avoid handling or moving the lamp while it is being charged.
Do not use the lamp if the battery or casing is suspected to be damaged.
If the battery is discharged, recharge it immediately and at least once every six months of non-use.
Avoid opening, disassembling, modifying, or servicing the battery pack.
Do not crush, puncture, short external contacts, or dispose of in fire or water.
Replace only with the designated battery pack for this product and dispose of used batteries properly.

Operation

To charge the lamp:

Connect the Micro USB cable to the charging port on the back of the light.
Plug into a power source and turn it on; the charging LED will light up RED to indicate charging has started.
Avoid turning on the lamp when it is being charged.
Avoid shining the light directly into your eyes.
Do not allow children to use the lamp.
Avoid handling or moving the lamp while it is being charged.
If you suspect damage to the battery or lamp casing, do not use the lamp.

Environmental Protection

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories, and packaging should be sorted and taken to a recycling center for proper disposal that is compatible with the environment. When the product is no longer usable and needs disposal, drain any fluids into approved containers anddispose of them according to local regulations.

WEEE Regulations: Dispose of this product in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). Contact your local solid waste authority for recycling information when the product is no longer needed.

FAQ

Q: Can I charge the lamp in damp conditions?
- A : No, do not charge the lamp in damp conditions as it may cause damage. Always charge in a dry environment.
Q: How often should I recharge the battery if not in use?
- A : Recharge the battery at least once every six months if not in use to maintain its performance.
Q: What should I do if the battery or lamp casing is damaged?
- A : Do not use the lamp if you suspect damage to the battery or lamp casing. Contact customer support for assistance.

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble-free performance.

IMPORTANT : PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

Refer to instructions

SAFETY

Inspect the cable and connector for wear and damage to ensure items are safe before connecting to the power supply. If worn or damaged DO NOT use.
Ensure the lamp is fully charged before initial use.
DO NOT charge in damp conditions.
DO NOT turn the lamp on when it is being charged.
DO NOT shine directly into your, another person’s or an animal’s eyes.
DO NOT allow children to use the lamp.
DO NOT handle or move the lamp whilst it is being charged.
DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
DO NOT leave the battery in a discharged state, recharge the battery immediately. Before storage, fully recharge the battery, and subsequently recharge the battery at least once every six months of non-use.
DO NOT attempt to open, disassemble, modify or service the battery pack.
DO NOT crush, puncture, short external contacts or dispose of in fire or water.
DO NOT expose to temperatures above 60°C (140°F).
Replace only with the battery pack designated for this product.
Recycle or dispose of used batteries as stipulated by local regulations.
If the electrolyte in the cells gets on your skin, thoroughly wash it with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.

INTRODUCTION

Mini, lightweight light with exclusive patented design owned by and registered to Sealey. The unique and innovative 360° swivel and tilt function enables the light source to be positioned in any direction. Featuring a super bright 3W COB LED light source, which gives an even and constant spread of light. Produces up to 300 lumens with a CRI-80 rating. Recessed lens for added protection. 1W SMD LED directional torch located on top of the light, produces up to 100 lumens. Rubber-covered magnet in base and swivel hook for hands-free operation. High-quality rechargeable 3.7V 1.5Ah Lithium-Polymer battery for longer life. Supplied with Micro USB cable.

SPECIFICATION

Model No: LED3601R, LED3601G, LED3601CF, LED3601

Battery: 3.7V 1.5Ah Li-Poly
LED Type: 3W COB + 1W SMD
Lumen Output Side/Top : 300/100lm
CRI Rating: (Side): 80
Operating Time Side/Top : 3/6hr
Charging Time : 3hr
IP Rating: IP20
Maximum Length : 170mm
Minimum Length : 160mm

The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time. We will provide a warranty against mechanical and electrical defects for a period of one year – this DOES NOT cover fair wear and tear. If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances, we will not replace the battery regardless of whether it is less than one year old.

NOTE: The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without another charge. (Not supplied with mains adaptor).

OPERATION

Connect the Micro USB cable to the charging port on the back of the light. Plug into the power source and turn on, the charging LED on the light will light RED to show charging has commenced.
When the battery has fully charged the LED will turn GREEN.
Direct the lens away from your eyes before switching on.
Toggle the light between 1W SMD end and 3W COB using the push switch.
Suspend the light by the hanging hook. When the light is hanging from the hook it can be rotated through 360° for more precise positioning.
Alternatively, use the magnet on the base to attach the light to any ferrous surface.

SEALEY-LED3601R.V3-Rechargeable-360-Degree-Inspection-Light-
fig1

BATTERY REMOVAL

Remove the 6 screws on the back of the lamp. Remove the back casing and disconnect the wiring from the circuit board. Remove the
battery mounting screws. Dispose of according to local government guidelines.

Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme.
Jack Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste. All tools, accessories, and packaging should be sorted, taken to a recycling center, and disposed of in a manner that is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.

WEEE REGULATIONS

Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.

NOTE : It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No Liability is accepted for incorrect use of this product.
WARRANTY : Guarantee is 12 months from purchase date, proof of which is required for any claim

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR