TAC TB-C07 Arrow Side Steps Running Boards Instruction Manual
- June 17, 2024
- TAC
Table of Contents
ARROWSIDESTEP
PART#:TB-C07
TB-C07 Arrow Side Steps Running Boards
FITS:| 2019-Up Chevy Silverado 1500 Regular Cab
2020-Up Chevy Silverado 2500-3500 Regular Cab
2019-Up GMC Sierra 1500 Regular Cab
2020-Up GMC Sierra 2500-3500 Regular Cab
---|---
| |
---|---|---
60-120min| Cutting Not Required| Drilling Not Required
Torque & Tools
Fastener Size| Tightening Torque (ft-lbs)| Wrench Required| Allen Wrench
Required
---|---|---|---
6mm| 7-8.5| | 10mm| | 4mm
8mm| 18-20| 13mm| 5mm
10mm| 35-40| 16mm| 6mm
12mm| 60-70| 18mm| 8mm
BEFORE INSTALLATION
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY BEFORE STARTING INSTALLATION.
ASSISTANCE IS RECOMMENDED.
PLEASE NOTE THAT THE FOLLOWING PICTURES ARE BASED ON THE DRIVER
SIDE INSTALLATION
STEP 1
Start the installation under the Driver/Left side of the vehicle. Remove the
plastic plugs along the bottom edge of the body, (Fig 1). Directly above each
threaded insert is a top mounting location on the side of the body panel. Hold
a Mounting Bracket up in place to help determine the correct mounting holes to
use along the body.
NOTE: Thread an 8mm Hex Bolt into the threaded inserts to clear paint as
required.
STEP 2
Select (1) Driver/Left Mounting Bracket. Attach the Mounting Bracket to the
front location with (2) 8mm x 30mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm
Flat Washers, (Fig 2). Do not fully tighten hardware.
STEP 3
Repeat Steps 1 & 2 to attach the remaining (1) Driver/Left Mounting Bracket
to the rear mounting location along the body panel, (Fig 3).
STEP 4
Select the Driver/Left Side Step.
NOTE: The Driver/Left Side Step will have a Sticker “D” on the front.
Insert (4) 6mm T-Bolts into the channels in the bottom of the Side Step, (Fig
4), (2 T-Bolts per channel). Attach the Side Step to the (2) Mounting Brackets
with (4) 6mm Flat Washers, (4) 6mm Lock Washers and (4) 6mm Hex Nuts, (Fig 5).
Do not tighten hardware.
STEP 5
Level and adjust the Side Step and fully tighten all hardware.
STEP 6
Repeat Steps 1—5 to attach the Passenger/Right Side Step.
STEP 7
Do periodic inspections to the installation to make sure that all hardware
is secure and tight.
Attention
To protect your investment, do not use any type of polish or wax that may
contain abrasives that could damage the finish.
Mild soap may be used also to clean the Side Steps.
www.tacautoparts.com
Customer Support: tac-office@tacautoparts.com
Rev. 9/29/22 (AE)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>