JBC FL50 Flux Bottle Instruction Manual

Table of Contents

JBC-FL50-Flux-Bottle-PRODUCT

The following items are included:

FL50 contains a liquid water-based flux developed for desoldering/soldering components and it is meant to be used in the preparation of printed circuits before soldering SMD components, especially flat-pack integrated circuits.
The bottle comes with a useful flexible nozzle which helps to refill small containers.
This flux is made under strict quality assurance and conforms to J-STD 004 as ORL0 type.
Note: Although residues of FL50 flux are minimal, they are water soluble for those cases where thorough cleaning is required.

How to use FL50

FL50 is meant to refill FL15 (Flux Bottle with Applicator) and FL(Refillable Brush Pen).
Note: Before flux application, clean and degrease the surface to be soldered.

FL15

FL

Wear protection glasses and gloves during handling.
Avoid contact with skin and eyes. It may cause sensitisation by skin contact and be irritating to the eyes and skin in case of lengthy contact.
Do not eat or drink. Harmful in case of ingestion.
In case of problems due to contact, ingestion or inhalation, seek medical advice.
First Aid Measures:
- Eyes: Flush with abundant clean warm water and seek first aid.
- Skin: Wash with soap and water.
- Inhalation of fumes: Move the affected person away from the source and outside to get fresh air. Seek medical help.
- Oral Ingestion: Drink plenty of clean water and seek immediate medical attention.
Wash your hands after use.
Any waste materials should be stored in sealed containers and disposed of according to the relevant Acts of Parliament and Local Authority Bylaws. Further advice can be obtained from your local waste disposal officer.
This product should only be used by authorised personnel who have been properly trained in its handling and use per good industrial hygiene and safety practices.
Keep away from children.

FL50 Flux Bottle (500 ml) Ref. FL-50

Cleaning Agent:
- Quantity: 500 ml
- Storage: Keep the container tightly closed Ideal temperature near 20 °C / 68 °F for 6 months
- Solvent: Water 98 % by mass and Organic activators 2% by mass (no conductive residues)
- Acid Value: 22 mg/ml
- Chloride Content: Halide free
- Corrosiveness: None
- Insulation Resistance: > 10 GΩ
- Dangerous substances: None Non flammable
- Ecological Information: Biodegradable
- Flux Classification: Conforms to J-STD 004 as ORL0 (no halide activator)
- Net Weight: 580 g / 1.279 lb
- Package Dimensions/Weight: 180 x 143 x 113 mm / 685 g (L x W x H) 7.09 x 5.63 x 4.45 in / 1.510 lb

JBC’s 2-year warranty covers this equipment against all manufacturing defects, including the replacement of defective parts and labour.
The warranty does not cover product wear or misuse.
For the warranty to be valid, equipment must be returned, postage paid, to the dealer where it was purchased.
This product should not be thrown in the garbage.
Following the European directive 2012/19/EU, electronic equipment at the end of its life must be collected and returned to an authorized recycling facility.