OUTPRIZE RML1430PB Pre Drilled Generator Inlet Box Instruction Manual
- June 17, 2024
- OUTPRIZE
Table of Contents
OUTPRIZE RML1430PB Pre Drilled Generator Inlet Box
Installation Instructions
- Power Inlet Box
- Sku#: RML1430PB
- Desc: 30A 125/250V
- NEMA: L14-30P
WARNING:
The inlet is not to be connected to power before installation. Failure to
comply with this instruction could result in an electrical failure, fire and
electrocution.
IMPORTANT : Installation of this power inlet box and related wiring must be done by a qualified electrician in compliance with all applicable electrical codes. When being used to power a structure, this inlet must be used in conjunction with a transfer switch. Not for indoor use. When using an engine-driven generator, located away from doors and windows to avoid the build-up of carbon monoxide from the engine exhaust in enclosed areas.
Installing the Power Inlet Box
Mount the power inlet box on the outside of the building in a convenient location, using the three holes provided in the back of the cabinet. Using copper wire only and approved wiring methods, run the wiring through one of the knockouts in the cabinet to a junction box located near the transfer switch. If using a conduit, pull at least four colors. Max Wire Gauge:10AWG Strip the wire insulation 3/5”(15mm, FIG1) (do not tin conductors) and connect the wires in the power inlet box as follows. Making sure there is no wire insulation in any terminal and the inlet terminal screws are tightened to 35 inch-pounds torque using Electric Phillips screwdriver
Cable Color Scheme:
- Black/Red=Load (250 Vlot), the terminals marked “X” and “Y”
- White=W-Neutral Conductor connected to “White” marking terminal.
- Green=Green power inlet wire to the green ground screw terminal on inside of the cabinet. If required, green wire to the green ground screw terminal on the inside of the cabinet.(FIG2)
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>