EKWB 3831109907306 Kinetic FLT Accent Silver Instruction Manual
- June 17, 2024
- ekwb
Table of Contents
EKWB 3831109907306 Kinetic FLT Accent Silver
Please note the installation of the product is intended to be undertaken by an adequately trained and experienced person. You are installing the product at your own risk. If you are not properly trained or experienced or feel unsure about the installation procedure, please refrain from installing the product yourself and contact our tech support for assistance. We disclaim our liability for any damages to the product as well as incidental, consequential, or indirect damages incurred due to improper inappropriate installation.
Before you start using this product, please follow these basic guidelines: Please carefully read the manual before beginning the installation process.
The EK Fittings require only a small amount of force to screw them firmly in place since the liquid seal is ensured by the rubber O-ring gaskets.
The use of corrosion-inhibiting coolants is always recommended for liquid cooling systems, and mandatory for nickel-plated water blocks.
Do not use pure distilled water! For best results, EK recommends the use of EK-Cryo Fuel coolants.
Make sure to thoroughly bleed air out of your water block, or you will not reach optimal performance.
BOX CONTENTS
MAIN PARTS
INSTALLING THE REPLACEMENT COVER
STEP 3
Take the replacement cover and install the LED strip onto the marked part.
Make sure the LED strip is facing as shown in the picture.
STEP 4
After securing the LED Strip, attach the replacement cover to the EK-Quantum
Kinetic FLT reservoir. Secure the cover with the saved
M4 × 22 DIN7991 Screws. Do not use excessive force!
STEP 5
It is essential to carry out a leak test after attaching the replacement
cover.
EK recommends using the EK-Loop Leak Tester Flex:
https://www.ekwb.com/shop/ek-loop-leak-tester-flex
CONNECTING THE D-RGB LED STRIP
STEP 1
Plug the 3 Pin connector from the reservoir D-RGB LED light to the DRGB HEADER on the motherboard. The LED will work if the pin layout on the header is as follows: +5V, Digital, empty, Ground Please ensure that the arrow indicated on the connector is plugged into the +5V line as indicated on your motherboard
If you put the LED Diode to the 12V RGB HEADER you can damage the LEDs. Failure to do so will damage your motherboard or LED strip.
SUPPORT AND SERVICE
In case you need assistance or wish to order spare parts, please contact: https://www.ekwb.com/customer-support/
For spare parts orders, refer to the page with “MAIN PARTS” where you can find
the EAN number of each part you might need.
Include the EAN number with the quantity in your request.
SOCIAL MEDIA
- FB: EKWaterBlocks
- TWITTERT :@EKWaterBlocks
- insta : ekwaterblocks
- youtube: EKWBofficial
- pinterts: ekwaterblocks
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>