CROSSIO R300 Ceiling Fan with Lights User Manual
- June 17, 2024
- CROSSIO
Table of Contents
CROSSIO R300 Ceiling Fan with Lights
Safety Rules
- Be sure the power to the wires you are working on is disconnected, either the fuse is removed or the circuit breaker is turned off. Turning the power off using the light switch is not sufficient to prevent electrical shock.
- The fan must be mounted with a minimum of 7 feet clearance from the trailing edge of the blades to the floor.
- Do not place any objects in the path of the blades.
- To avoid personal injury or damage to the fan and other items, be cautious when working around or cleaning the fan.
- To reduce the risk of personal injury, do not bend the blade brackets (also referred to as flanges) during assembly or after installation. Do not insert objects in the path of the blades.
Clean And Care
Wipe the fixture with soft cloth. Spray from chemical cleaners can discolor the finish of the fixture. Do not use scouring pads, powders, steel wool or abrasive paper to clean this fixture.
Packing List
Installation kit
- Step 1: Make sure to cut off the power before installation
- Step 2: Install the whole lamp on the extender and socket.
- Step 3: Installation finished, Turn on the power. Then you can use the ceiling fan by the remote control.
Remote Control Instructions
NOTE: Please remove the plastic insulation gasket before using the remote control. CR2025 3V battery x 1pcs (included).
Trouble Shooting
- Fan doesn’t work
- Make sure the lamp holder connected to the fixing device is working properly.
- Check the circuit breaker to ensure the power is on.
- Lights Do Not Light Up / Flicker / Noisy Operation
- Check your power and switch to make sure it’s power on.
- Noisy Operation
- Check to see if any of the blades are cracked. If so, Contact us.
- Remote does not work
- Make sure the battery is installed correctly.
- Install 1 new batteries (CR2025).
Scan for Installation Video
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>