SEALEY LED317 Rechargeable 3W COB and 3W SMD LED Inspection Light Instructions
- June 17, 2024
- SEALEY
Table of Contents
SEALEY LED317 Rechargeable 3W COB and 3W SMD LED Inspection Light
Product Information
Specifications
- Model: LED317
- Light Type: 3W COB & 3W SMD LED Rechargeable Inspection Light
- Charging: USB charging
- Operating Modes: End light and side light
- Warranty: 1 year against mechanical and electrical defects (does not cover fair wear and tear)
Product Usage Instructions
Safety
General Safety:
- Ensure the lamp is fully charged before initial use.
- DO NOT turn the lamp on when it is being charged.
- DO NOT shine directly into eyes.
- Keep away from children.
- DO NOT handle or move the lamp while charging.
- DO NOT use if battery or lamp casing is damaged.
- Recharge battery at least once every six months of non-use.
Battery Safety:
- DO NOT attempt to open, disassemble, modify, or service the battery pack.
- Recycle or dispose of used battery as per local regulations.
- If electrolyte contacts skin, wash with soap and water. If in eyes, rinse with cool water and seek medical attention.
Operation
Charging the Lamp:
Connect the USB lead to the socket on the rear of the lamp. Plug into a power supply and turn on. When fully charged, LEDs will turn GREEN.
Operating the Lamp:
Direct the lens away from your eyes before switching on. Toggle between end light and side light using the mode selector switch. Lamp can be suspended by hook or attached to ferrous surface using magnet.
Maintenance
- Clean the lamp by wiping with a damp cloth.
- Store in a dry, childproof area.
Warranty Information
The battery is considered consumable; its ability to accept a charge may reduce over time. Warranty covers mechanical and electrical defects for one year, excluding fair wear and tear. Proper charging and maintenance are essential to maintain battery capacity.
FAQ
Q: Can I leave the lamp on while it is being charged?
A: No, DO NOT turn on the lamp when it is being charged as per safety instructions.
Q: How often should I recharge the battery if not in use?
A: Recharge the battery at least once every six months if not in use to maintain its performance.
Q: What should I do if the battery capacity diminishes?
A: If the battery capacity diminishes due to improper charging or maintenance, it may not be covered under warranty. Properly charge and condition the battery to maintain its capacity.
Q: How should I dispose of the product at the end of its working life?
A: Dispose of the product in compliance with WEEE regulations. Contact your local solid waste authority for recycling information.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
SAFETY
GENERAL SAFETY
- Ensure the lamp is fully charged before initial use.
- DO NOT turn the lamp on when it is being charged.
- DO NOT shine directly into your, another person’s or an animal’s eyes.
- DO NOT allow children to use the lamp.
- DO NOT handle or move the lamp whilst it is being charged.
- DO NOT use the lamp if you suspect that the battery or the lamp casing is damaged.
- DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use.
BATTERY SAFETY
- WARNING! To reduce the risk of burns or fire:
- DO NOT attempt to open, disassemble, modify or service the battery pack.
- DO NOT crush, puncture, short external contacts or dispose of in fire or water.
- DO NOT expose to temperatures above 60°C (140°F).
- Recycle or dispose of used battery as stipulated by local regulation.
- If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention.
INTRODUCTION
Mini, lightweight light. Featuring a super bright 3W COB LED, which gives an even and constant spread of light, producing up to 250 lumens. 3W High power SMD LED torch producing up to 100 lumens. Integral hanging hook/belt clip and a magnetic base which can rotate through 180° for hands-free applications. Features a battery level indicator. Rechargeable 3.7V 1.2Ah lithium-ion battery for longer life. Supplied with micro USB cable.
SPECIFICATION
- Model No:………………………………………………………..LED317
- Battery………………………………………… 3.7V 1.2Ah Lithium-ion
- Charging Time………………………………………………………..2.5hr
- IP Rating………………………………………………………………. IPX4
- LED Qty…………………………………………..3W COB + 3W SMD
- Length………………………………………………………………. 155mm
- Lumen Outputs……………………………………………… 250/100lm
- Operating time………………………………………………………….3hr
OPERATION
CHARGING THE LAMP
- Connect the USB lead to the socket on the rear of the lamp.
- Plug the USB lead into a power supply and turn on.
- When the battery has fully charged, the LEDs will turn GREEN.
OPERATING THE LAMP
- WARNING! Direct the lens away from your eyes before switching on the lamp.
- Toggle the lamp between the end light and side light using the m ode selector switch (fig.1).
- The lamp may be suspended by the hook or attached to any ferrous surface by using the magnet.
MAINTENANCE
- Keep the torch clean by wiping with a damp cloth.
- Store the torch in a dry childproof area.
- IMPORTANT WARRANTY INFORMATION
- The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.
- We will provide a warranty against mechanical and electrical defects for a period of one year – this DOES NOT cover fair wear and tear.
- If the battery is not properly charged before first use, or regu larly conditioned, its capacity will diminish.
- Under these circumstances, we will not replace the battery regardless of whether it is less than one year old.
- WEEE REGULATIONS
- Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information.
- BATTERY REMOVAL
- Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705
- ENVIRONMENT PROTECTION
- Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations.
Note: It is our policy to continually improve products and as such we
reserve the right to alter data, specifications and component parts without
prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: The guarantee is 12 months from the purchase date, proof of
which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
- 01284 757500
- [email protected]
- www.sealey.co.uk
REGISTER YOURPURCHASE HERE
Documents / Resources
|
SEALEY LED317 Rechargeable 3W COB and 3W SMD LED Inspection
Light
[pdf] Instructions
LED317 Rechargeable 3W COB and 3W SMD LED Inspection Light, LED317,
Rechargeable 3W COB and 3W SMD LED Inspection Light, 3W COB and 3W SMD LED
Inspection Light, LED Inspection Light, Inspection Light
---|---