MIDLAND BEEPER ONE GPS Gas Locator For Dogs User Guide
- June 17, 2024
- MIDLAND
Table of Contents
MIDLAND BEEPER ONE GPS Gas Locator For Dogs
SETTINGS
| CALIBRATION| Calibration of the compass on the remote control
---|---|---
| COMPASS| Indicates the North in relation to my position
| RINGTONE| Activation/deactivation of the remote control ringtone (3 levels)
| VIBRATION| Enabling/Disabling the vibration of the remote control
| BRIGHTNESS| Brightness level of the display (3 levels)
| CONTRAST| To set light or dark mode on the display
| CHANNEL| TX channels and output power; you can set up to 5 radio channels
| LANGUAGE| Menu language: Italian, English, Spanish and French
| INFO| General info about the remote control
| SAVE PLACE| Saves the coordinates of a place on the remote control
| FIND PLACE| The arrow indicates the distance and direction of a saved place
PAIRING
Remote control off.
Place beeper into the charger cradle, the led will be flashing fast for 30
seconds. During the pairing, also the channel will be set on the beeper.
RECHARGE
LED
OFF
Switched of| FAST FLASH
Pairing
---|---
INTERMITTENT FLASH
Being charged| STEADY
Full charge
BEEPER ONE GPS – KEY DESCRIPTION
Frequency: 433.775 – 434.200MHz
Power: ≥ 10mW
REMOTE CONTROL
-
Power ON/OFF
-
Display
-
Menu
-
OK
-
Dog 1
-
1 Beeper beep
-
Beeper beep OFF
-
Beeper power ON (magnet)
-
Hole for lanyard
-
USB port for recharge/FW upgrade
-
Beeper volume (3 levels)
-
Beeper vibration
-
Dog 2
-
Exit
BEEPER -
Speaker cap
-
LED
-
Collar loops
-
Power ON magnetic sensor
DISPLAY
- A. DOG 1 indications
- B. DOG 1 battery indications
- C. DOG 1 radio signal
- D. DOG 1 GPS
- E. Distance and direction of the selected dog
- F. DOG 2 distance and direction
- G. DOG 2 radio signal
- H. DOG 2 battery indications
- I. DOG 2 indications
- J. Remote control vibration and/or sounds
- K. Remote control battery
- L. Remote control GPS
- M. Remote control NORTH
POWER ON
-
REMOTE CONTROL
-
BEEPER
To switch on the Beeper and the Remote Control you must not be in motion. Wait also for a proper GPS signal.
POWER OFF
-
REMOTE CONTROL
-
BEEPER
CALIBRATION
We suggest calibrating the remote control at every use. A distance inferior to 15m could be not so precise.
STEP 1
STEP 2
STEP 3
DOG IN MOTION
We suggest calibrating the remote control at every use. A distance inferior to 15m could be not so precise.
POINTING DOG
The first pointing dog will be automatically selected on the display.
Customer Support
Distributed by: Canicom Srl
Via di Sottopoggio, 32 – 55012 Guamo, Lucca – Italy
Technical support:
Tel: +39 0583 462363 Fax +39 0583 462411
mail: info@canicomitalia.com
web: canicomitalia.com
Imported by:
MIDLAND EUROPE srl
Via. R.Sevardi 7 – 42124 Reggio Emilia – Italy
Read the instructions carefully before installation and use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>