YITAMOTOR CETMTM-0093 Towing Mirrors Compatible Instruction Manual

CETMTM-0093 Towing Mirrors Compatible

CETM-0084
CETM-0087
CETMTM-0093
CETMTM-0094
CETMTM-0097

Notes
Read this instruction carefully before starting installation.
Proper tools will improve the quality of installation and reduce the time required.
All mirrors are asymmetrical design for better view range.
For vehicles without factory heat and signal light functions require an additional wiring.
Power fold/Memory/Auto-Dimming functions are not available.
If missing parts or any damage found, please take a picture and contact us.
Reference the vehicle owner’s manual to adjust the new mirrors.

Step 1:

1. Open the front door to remove the upper extension triangular trim panel.
2. Remove (2) small covers from door handle grab and inner door lever.
3.  Reomve
4. Remove (4) 7mm bolts behind those covers.
5. Remove (2) 7mm bolts from the bottom of the door trim panel.
6. Carefully pull the door trim panel up and release door trim panel.
7. Disconnect the door switch harness connectors.
8. Carefully release the door lock cable.
9. Remove the door trim panel.

Step 2:

1. Disconnect the mirror harness connector.
2. Remove (3 or 4) 10mm hex nuts securing the factory mirror.
3. Carefully remove the factory mirror.

Step 3:

1. For vehicles equipped regualr mirror, drill an additional 10mm hole on door sheet panel.
2. Take the new mirror, feed studs and harness through the existed holes on door sheet panel.
3. Install (4) provided hex nuts to secure the new mirror. Torque to 80 lb in.
4. Connect the mirror harness connector.

Step 4:

1. Take the door trim panel, connect door switch harness connectors.
2. Reinstall the door lock cable.
3. Feed the door lock tab through the hole on door trim panel, engage clips and hooks behind door trim panel.
4. Secure the door trim panel using (6) 7mm bolts.
5. Reinstall the inner door lock lever and door grab covers
6. Reinstall the door switch trim panel.
7. Reinstall the upper extension triangular trim panel.

Step 5:

1. Repeat above steps on the passenger side.
2. Carefully check all mirrors functions before first drive.
3. For vehicles with memory and tilt functions please disable functions on vheicle’ s driver information center.

Reference Wire Diagram:

1: Not Used
3-6: Not Used
8: Mirror Heater
12-17: Not Used| 2: Signal Light
7 /9/10: Mirror Motor
11: Mirror Heater
18: Signal Ground
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>