YITAMOTOR CEETSS-1009-1 Running Boards Installation Guide

CEETSS-1009-1 Running Boards
Installation Guide

CEETSS-1009-1 Running Boards

CARE AND USE INSTRUCTIONS
CEETSS-1009

Tools Required
13mm Socket
Ratchet
Torque Wrench

Notes
Read this instruction carefully before starting installation.
Proper tools will improve the quality of installation and reduce the time required.
Verify the direction of brackets before installation.
If missing parts or any damage found, please take a picture, and contact us.
Professional installation would be highly recommended.
Step 1:

1. Locate (3) mounting positions on each side inner rocker panel.
2. Remove factory plugs or hex bolts from mounting positions.
3. Clean the sealant and dirt around mounting positions.

Step 2:

1. Attach the bracket to the thread inserts on inner rocker panel.
2. Secure the bracket to inner rocker panel with (2) M8 x 25 hex bolts, (2) M8 lock washers, (2) M8 flat washers.
   Note: The front brackets are larger and heavier than the center and rear brackets

Step 3:

1. With assistance, lift and attach the step bar to the brackets.
2. Secure (3) support brackets and step bar onto brackets with (9) M8 flat washers, (9) M8 lock washers, (9) M8 x 30 hex bolts.

Step 4:

1. Tighten M8 hex bolts on vehicle with 15 ft. lbs. torque.
2. Adjust the step bar to level and tighten M8 hex bolts with 15 ft. lbs. torque.
3. After the step bar installed, periodic check to ensure all mounting hardware remains secure and tight.

Part List:

| Qty.| Description
---|---|---
1| x 12| M8X25 Hexagon Bolt
2| x 18| M8X30 Hexagon Bolt
3| X 30| MS X 20 Flat Washer
4| X 30| MS Lock Washer
5| Xl| Front Driver Side Bracket
6| X1| Front Passenger Side Bracket
7| X2| Center/Rear Driver Side Bracket
8| X2| Center/Rear Passenger Side Bracket
9| X6| Support Bracket

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>