YITAMOTOR CEETSS-0041 6 inch Running Boards Instructions

YITAMOTOR CEETSS-0041 6-inch Running Boards

Before Installation

• Read this instruction carefully before starting installation.
• Proper tools will improve the quality of installation and reduce the time required.
• It is NOT compatible with a diesel engine vehicle.
• If missing parts or any damage is found, please take a picture and contact us.
• Professional installation would be highly recommended.

Step 1

1. Locate (3) mounting positions on each side.
2. Remove the rubber plugs on the inner rocker panel.
3. Insert clip nuts onto existing holes in the inner rocker panel.
   Note: Some vehicles may equipped with threaded inserts in the rocker panel, use them directly in step 2.

Step 2

1. Attach the bracket to the inner rocker panel and secure it with (1) M8 hex bolt, and (1) M8 flat washer.
2. Secure the bracket to pinch weld with (1) M8 hex bolt, (1) M8 flat washer, (1) M8 hex nut.
3. Repeat to install the remaining brackets, do not fully tighten.

Note
For vehicles with factory-threaded inserts and weld nuts, clean the rust and dirt around the threads before installation. Proper lubrication is required.

Step 3

1. Remove (6) M8 hex bolts and (6) M8 flat washers from the step bar.
2. Slide mounting tracks to proper positions.
3. With assistance, lift and attach the step bar to brackets.
4. Secure the step bar on brackets with (6) M8 hex bolts and (6) M8 flat washers.
5. Repeat to install the other side step bar, do not fully tighten.

Step 4

1. Tighten M8 hex bolts and nuts on a vehicle with 15 ft-lbs. torque.
2. Adjust the step bar to level and tighten M8 hex bolts with 15 ft-lbs. torque.
3. After the step bar is installed, periodic checks to ensure all mounting hardware remains secure and tight.

Part List

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>