Futaba R603FF 3 Channel FASST Receiver User Manual

June 17, 2024
Futaba

Futaba R603FF 3 Channel FASST Receiver

Specifications:

  • Model: R603FF
  • Compatibility: Surface Models
  • Connectors: 3: CH3 servo (CH3), 2: Throttle servo (CH2), 1: Steering servo (CH1), B/C: Power connector/DSC connector, RS232C: (for factory use only)
  • Antenna: Coaxial cable

How to Link the Transmitter and the Receiver:
Each transmitter has an individually assigned, unique ID code.
To start operation, the receiver must be linked with the ID code of the transmitter.

Link Procedure:

  1. Bring the transmitter and receiver close to each other, within one meter.
  2. Turn on the transmitter and check the LED for RF signal transmission.
  3. Turn on the receiver.
  4. Push the tactile switch of the receiver.
  5. When the link is complete, the LED in the receiver changes to solid green.

INTRODUCTION

Futaba-R603FF -Channel-FASST-Receivr-Connectors

  • 3: CH3 servo (CH3)
  • 2: Throttle servo (CH2)
  • 1: Steering servo (CH1)
  • B/C: Power connector/DSC connector RS232C: (for factory use only)

Futaba-R603FF -Channel-FASST-Receivr-1

How to link the transmitter and the receiver

Each transmitter has an individually assigned, unique ID code. In order to start operation, the receiver must be linked with the ID code of the transmitter with which it is being paired. Once the link is made, the ID code is stored in the receiver and no further linking is necessary unless the receiver needs to be used with an other transmitter. (For T/R set, the link is already done at factory.)

Link procedure

  1. Bring the transmitter and the receiver close to each other, within one meter.
  2. Turn on the transmitter
  3. Check the LED that is placed on the back side of the transmitter to see if the RF signal is transmitted. When the green LED is solid ON, the RF signal is transmitted.
    Please refer the table below for LED status vs transmitter’s condition.

LED status vs transmitter’s condition:
Futaba-R603FF -Channel-FASST-Receivr-3

  1. Turn on the receiver.
  2. Push the tactile switch of the receiver .
  3. When the link is complete, the LED in the receiver changes to solid green.
  • Please refer the table below for LED status vs receiver’s condition.

LED status vs receiver’s condition

Futaba-R603FF -Channel-FASST-
Receivr-5

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals