The Home Depot TT-6 Two Piece Toilet Instruction Manual

The Home Depot TT-6 Two Piece Toilet

Product Information

Specifications:

• Product Name: Two-Piece Toilet with 12 Rough-In
• Model Number: TT-6
• Rough-In Size: 12 inches
• Material: Ceramic

Product Usage Instructions

Installation:

1. Ensure that your water inlet pipe and floor discharge drain meet the minimum measurements as indicated in the manual.
2. Install the floor flange according to the manufacturer’s recommendations.
3. Position the fixing bolts of the floor flange and use the provided plastic nuts to secure them.
4. Attach the seal ring onto the toilet’s drain, fixing it to the ceramic.
5. Position the toilet on the floor flange, aligning the fixing bolts with the toilet’s holes.
6. Tightly screw the nuts to the fixing bolts using an adjustable wrench. Cover the hole with the provided cover.
7. Secure the bolts inside the tank by screwing the nuts at the bottom of the tank. Ensure they are strongly tightened.
8. Install the rubber ring under the tank and then place the tank on the toilet body.
9. Fix the tank to the toilet by installing nuts underneath. Ensure they are strongly tightened to prevent leaking.
10. Connect the toilet to the water inlet valve using a supply line (not supplied).
11. Install the seat cover with its fixing hardware and decorative caps. Adjust the seat position before tightening.
12. Insert the seat onto the toilet by pushing the two buttons and securing it to the fixing pegs.

Frequently Asked Questions (FAQ)

• Q: Can I install the toilet if my actual measurements are longer than the minimum requirements?
  A: Yes, you can install the toilet if your actual measurements are longer than the minimum requirements specified in the manual.

• Q: How do I prevent leaking when installing the flush tank?
  A: To prevent leaking, ensure that the nuts securing the tank to the toilet are strongly tightened during installation.

Two-Piece Toilet with 12″ Rough-In

INSTALLATION

• Ensure that your water inlet pipe and your floor discharge drain are installed according to bellow drawing. These are minimum measurements, the toilet can be installed if your actual measurements are longer than below

• Install the floor flange according to the manufacturer’s recommendations

• Position correctly the two fixing bolts of the floor flange. Then use the provided plastic nuts to help immobilize the bolts for subsequent steps.

• Firmly push the seal ring onto the toilet’s drain, fixing the seal ring to the ceramic.

• Position the toilet onto the floor flange, making sure the fixing bolts are aligned with the toilet’s holes.

• Using an adjustable wrench, reach beside the toilet and tightly screw the nut to the fixing bolts. Cover the hole with the provided cover.

• Push down the pre-installed bolts from inside the tank, and secure the bolts by screwing the nuts located at the bottom of the tank. Strongly tighten the nuts.

• Install the rubber ring under the tank. Install the tank on the toilet body.

• Install the 2 nuts under the toilet to fix the tank.
  Warning : To prevent leaking, ensure that the nuts are strongly tightened when you install the flush tank onto the toilet.

• Connect the toilet to your water inlet valve, using the supply line (not supplied).

• Install the seat cover with its fixing hardware and with its decorative caps.
  Before tightening, move the pegs front and back to yield the desired seat position

• Insert the seat onto the toilet by pushing the two buttons and securing it to the fixing pegs.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>