GE APPLIANCES RAG26AA Architectural Aluminum Louvered Extruded Grille Instruction Manual
- June 17, 2024
- GE Appliances
Table of Contents
GE APPLIANCES RAG26AA Architectural Aluminum Louvered Extruded Grille
Product Information
Specifications
- Product Name: RAG26AA Aluminum Architectural Rear Grille
- Compatibility: Designed for 26 GE Appliances Through the Wall AC Wall Sleeves
- Material: Aluminum with stainless steel screws
Product Usage Instructions
Facility
Step 1: Check for Proper Orientation
- Before installation, ensure that the grille is oriented correctly with louvers pitching downward.
Step 2: Aligning Grille with Wall Sleeve
- Firmly grasp the grill and ribbon handle, tilt the grill to insert through the wall sleeve, ensuring tabs are in place.
Step 3: Mounting Grille to Wall Sleeve
- Hold the grid securely with two hands to prevent falls or accidents.
- Align the tabs and securely attach the grille to the wall sleeve.
Step 4: Securing Grid
-
Tighten the four mounting screws using a 1/4 nut driver to secure the grill tabs to the wall sleeve.
-
Remove the ribbon handle after installation.
FAQ
Q: What should I do if I notice condenser air recirculation after installing the grille?
- A: If you observe condenser air recirculation, immediately discontinue use and recheck the installation to ensure proper orientation and attachment of the grille.
Q: Can I paint or customize the Aluminum Architectural Rear Grille?
- A: It is not recommended to paint or customize the grille as it may affect its performance and durability. Any modifications may void the warranty.
- Before you begin – Read these instructions completely and carefully.
- IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
INTRODUCTION
- These instructions cover the installation of the Aluminum Architectural Rear Grille accessory for 26” GE Appliances Through the Wall AC Wall Sleeves.
- The grille securely attaches to the rear of the wall sleeve with four pre-set stainless steel screws and tabs.
TOOLS NEEDED
- 1/4” Nutdriver
- Pliers
CAUTION
- Improper installation of the accessory grille could result in condenser (outdoor) air recirculation.
- This will degrade the performance of the unit and possibly shorten product life.
- The manufacturer does not assume responsibility for the improper installation of the grille resulting in condenser air recirculation.
INSTALLATION INSTRUCTION
IMPORTANT: Check For Proper Orientation
- Before attempting to install the grille, be sure to check it for proper orientation.
- The grille should be oriented with louvers pitching downward.
STEP 1
- Remove the sleeve stiffener or weather barrier (if present). (To prevent dropping the panel, push out the slit in the center of the outdoor panel to use as a handhold.)
- STEP 2: Aligning Grille with Wall Sleeve
- Firmly grasp the grille by holding the grille with one hand and the ribbon handle with the other hand.
- Tilt grille to insert through the wall sleeve and out the back of the wall sleeve. Make sure the tabs are in place
WARNING When installing the grille, be sure to securely hold it with 2 hands to prevent it from falling and causing injury or damage.
- STEP 3: Mounting Grille to Wall Sleeve
- Line up the 4 mounting tabs on the grille, making sure they overlap the wall sleeve flange. Rotate them to their vertical position and tighten the screws fully.
- STEP 4: Securing Grille
- Tighten the four mounting screws with a 1/4″ nut driver to secure the grille tabs to the wall sleeve.
- Remove the ribbon handle after the installation is complete.
Read User Manual Online (PDF format)
Loading......