GE APPLIANCES RAG42PD Zoneline Architectural Rear Grille Instruction Manual
- June 17, 2024
- GE Appliances
Table of Contents
GE APPLIANCES RAG42PD Zoneline Architectural Rear Grille
Product Information
Specifications
- Product Model: RAG42P*
- Material: Polymer
- Compatibility: Packaged terminal air conditioner and heat pump
- Mounting: Four pre-set stainless steel screws
Product Usage Instructions
STEP 1: Check For Proper Orientation
- Before installation, ensure the grille is oriented with louvers pitching downward.
STEP 2: Aligning Grille with Wall Sleeve
- Back out the four (4) mounting screws slightly. Hold the grill with two hands, tilt it to insert through the wall sleeve, and out the back.
STEP 3: Mounting Grille to Wall Sleeve
- Align and insert the grille mounting screws into the keyhole slots on the back of the wall sleeve.
STEP 4: Securing Grid
- Tighten the four mounting screws to securely attach the grill to the wall sleeve.
FAQs
Q: What should I do if I encounter condenser air recirculation after installation?
- A: If you notice condenser air recirculation, immediately discontinue use and recheck the installation following the proper orientation steps provided in the manual.
Q: Can I use this grille with any other type of air conditioning unit?
-
A: The Polymer Architectural Grille is specifically designed for use with packaged terminal air conditioners and heat pumps.
-
It is not recommended for use with other types of units.
Q: Is it necessary to tighten the mounting screws securely?
- A: Yes, it is crucial to tighten the mounting screws securely to prevent any potential hazards or damage caused by loose fittings.
- Before you begin – Read these instructions completely and carefully.
- IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.
INTRODUCTION
- These instructions cover the installation of the Polymer Architectural Grille accessory for the packaged terminal air conditioner and heat pump.
- The grille securely attaches to the rear of the wall sleeve with four pre-set stainless steel screws.
- CAUTION Improper installation of accessory grille could result in condenser (outdoor) air recirculation.
- This will degrade the performance of the unit and possibly shorten product life.
- The manufacturer does not assume responsibility for the improper installation of the grille resulting in condenser air recirculation.
INSTALLATION INSTRUCTION
- STEP 1: Check For Proper Orientation
- Before attempting to install the grille, be sure to check it for proper orientation.
- The grille should be oriented with louvers pitching downward.
- STEP 2: Aligning Grille with Wall Sleeve
- Back out the four (4) mounting screws approx. 1/4” to 5/16”. Firmly grasp the grille with two (2) hands.
- Tilt grille to insert through the wall sleeve and out the back of the wall sleeve.
- WARNING When installing the grille, be sure to securely hold it with two (2) hands to prevent it from falling and causing injury or damage.
- STEP 3: Mounting Grille to Wall Sleeve
- Line up and insert grille mounting screws into keyhole slots on the back of the wall sleeve.
- STEP 4: Securing Grille
- Tighten the four mounting screws to secure the grille to the wall sleeve.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>