GE APPLIANCES RAG42AA Zoneline Architectural Rear Grille Instruction Manual

Table of Contents

GE-APPLIANCES-RAG42AA-Zoneline-Architectural-Rear-Grille-
product

Specifications

Tools Needed

Ensure you have the following tools:

Installation

Step 1: Check for Proper Orientation

Step 2: Aligning Grille with Wall Sleeve

Back out the (4) mounting screws slightly. Tilt the grille to insert through the wall sleeve and out the back.

Step 3: Mounting Grille to Wall Sleeve

Line up and insert grille mounting screws into keyhole slots on the back of the wall sleeve.

Step 4: Securing Grille

Tighten the four mounting screws with a 1/4 nut driver to secure the grille to the wall sleeve.
Remove the ribbon handle after installation is complete.

FAQ

Q: What should I do if I encounter condenser air recirculation after installing the grille?

A: If you notice condenser air recirculation, immediately discontinue use and recheck the installation to ensure proper orientation and secure mounting.

Q: Can this grille be used with drain kits?

A: Yes, the RAG42AA grille can be used with drain kits. Follow the same installation steps provided in the manual.
Before you begin – Read these instructions completely and carefully.
IMPORTANT – OBSERVE ALL GOVERNING CODES AND ORDINANCES.

These instructions cover the installation of the Aluminum Architectural Rear Grille accessory for the packaged terminal air conditioner and heat pump.
The grille securely attaches to the rear of the wall sleeve with four pre-set stainless steel screws.
This grille is compatible with all RAB71, RAB81, and RAB78 series wall sleeves.

CAUTION

Improper installation of the accessory grille could result in condenser (outdoor) air recirculation.
This will degrade the performance of the unit and possibly shorten product life.
The manufacturer does not assume responsibility for the improper installation of the grille resulting in condenser air recirculation.

IMPORTANT: Check For Proper Orientation Before attempting to install the grille, be sure to check it for proper orientation.
The grille should be oriented with louvers pitching downward.

STEP 1

Remove the sleeve stiffener. Remove the rear (outside) panel from the room side by bringing the panel through the sleeve into the room.
To prevent dropping the panel, push out the slit in the center of the outdoor panel to use as a handhold.)
STEP 2 : Aligning Grille with Wall Sleeve
Back out the (4) mounting screws approx. 1/4″ to 5/16″.
Firmly grasp the grille by holding the grille with one hand and the ribbon handle with the other hand.
Tilt grille to insert through the wall sleeve and out the back of the wall sleeve.
WARNING When installing the grille, be sure to securely hold it with 2 hands to prevent it from falling and causing injury or damage.
STEP 3: Mounting Grille to Wall Sleeve
Line up and insert grille mounting screws into keyhole slots on the back of the wall sleeve.
STEP 4: Securing Grille
Tighten the four mounting screws with a 1/4″ nut driver to secure the grille to the wall sleeve.
Remove the ribbon handle after the installation is complete.